User manual

Change settings 21
Projector system settings
1 Press on the remote control to
access the projector system setting options.
2 Use the Navigation buttons and OK to select
and change settings.
Source selection
• Select and activate an input source
corresponding to an external device which
is connected to the projector.
• Select Smart Media when a USB storage
device is connected or no other external
device is connected.
Notice
If no input source is detected, NO SIGNAL
appears on the screen.
Depending on which source you have
selected, the sub menus may vary.
Image settings
• Smart Settings: Select a predefined setting
based on brightness, contrast and color
saturation.
• Format: Select a picture format to fit the
projection screen.
• Adjust Brightness/Contrast/Saturation/
Sharpness with the values from 0 to 100.
• Lamp Power Mode: Select a lamp power
mode to be used in different situations.
• Cinema: Ideal for very dark rooms and
smaller screen sizes.
• Daylight: Ideal for bright environment.
• Primetime: Ideal for semi-darkness.
• Flow Motion: Switch MEMC (motion
estimation motion compensation) for
motion interpolation to alleviate display
motion blur.
• Wall Colour Correction: Adjust colour of the
projected image to the coloured projection
surface.
• Advanced Colour Settings: access the
detailed colour corrections.
• Colour Temperature: Set to Warm to
enhance hotter colours such as red;
set to Cool to make picture bluish.
• Dynamic Contrast: Adjust the contrast
to keep it at the best level according to
the brightness of the screen.
• Gamma: Adjust the gamma correction
according to the type of the projected
image.
• Black Level: Set the black and white
level to Full Range, Limit Range or Auto.
• Manual White Point: Manually adjust
the white point calibration according to
your needs.
• Manual Colours RGB CMY: Manually
adjust colours in RGB CMY mode
according to your needs.
3D setting
• 3D: Switch the picture mode between
2D or 3D.
• L/R Swap: Switch the left and right side of
the screen display.