User manual

General safety information 5
Power supply
Before turning on your device, check that the
outlet that you are going to plug it into con
-
forms to the indications shown on the informa-
tion plate (voltage, current, power network fre-
quency) located on your device. This device
shall be connected to a single phase power
network. The device shall not be installed on
bare ground.
Only use the power cable that is supplied with
your device. Your device is delivered with a
grounded power cable. It is imperative to con
-
nect a grounded connector to a grounded out-
let connected to the building earthing.
The socket outlet shall be installed near the
device and shall be easily accessible.
To remove all electrical power from the device,
disconnect the power cable from the electrical
outlet. Only in case of danger, the power cable
is the disconnect device for this projector.
Turn off the device and unplug from the power
outlet before cleaning the surface. Use a soft,
lint-free cloth. Never use liquid, gaseous or eas
-
ily flammable cleansers (sprays, abrasives, pol-
ishes, alcohol). Do not allow any moisture to
reach the interior of the device.
3D glasses use
When using 3D glasses at home, keep in mind:
3D glasses must be kept out of reach from
small children, due to risk of small parts
being ingested;
3D glasses are not intended for use by
children under the age of six;
children between age six and adulthood
should not use the glasses for longer than
the duration of one film;
the same time limit is also recommended
for adults;
3D glasses are intended strictly for watch-
ing 3D content only;
undertake a thorough and regular clean-
ing and disinfection in case of eye infec-
tion, head-lice infestation, etc. In cases
where disinfection of the 3D glasses is not
possible, as it may damage the functional
-
ity of the 3D glasses, the user must be
informed that use of the 3D glasses is not
recommended until the issues have been
resolved;
3D glasses are to be used together with
the regular eye-wear of the user (eye-
glasses or contact lenses).
Dolby digital
Manufactured under license from Dolby Labo-
ratories. Dolby and the corresponding logo are
trademarks of Dolby Laboratories.
CAUTION!
Always use the B button to turn off the
projector. This is essential to allow the
necessary cooling-down time for the
UHP lamp!
DANGER!
Risk of eye irritation!
This device is equipped with a long-life
UHP lamp, which emit very bright light.
Do not look directly into the projector
lens during operation. This could cause
eye irritation or damage.
CAUTION!
You should stop watching 3D in the
event of the occurrence of eye prob
-
lems or discomfort, and in the event of
a persistence of any issues, consult a
doctor.