User manual

14 Philips · HDP2510
Initial installation
1 Turn the device with the rear side towards a
suitable projection surface or wall. Note that
the distance to the projection surface must
be a minimum of 0.1
meter and a maximum of
0.42 meter
(see Setting up the device,
page 4). Make sure the projector is in a secure
position.
Turning on the projector
1 To turn on the projector, press the B button
on the panel control of the device or on the
remote control once.
2 Use the FOCUS buttons N/O to adjust the
image sharpness.
3 The first time you turn on the device, you
need to set the following settings.
4 Use ¡/¢ to select the language and con-
firm with OK.
5 Use ¡/¢ to select the location and confirm
with OK.

Home: For normal use.
Shop: When you choose this option, the pro-
jector starts in shop mode. In this mode
default settings are made and can’t be
changed.
Notice
The turning on and off of the projector
requires some time, as the UHP lamp
must reach the operational tempera
-
ture. After a few minutes the brightness
reaches its full capacity.
Notice
During the first installation, use OK to
validate your choice and continue to
the next step, and ¿ to return to the
previous step.
Notice
The shop mode can be activated or
deactivated on the Option menu
(see
Shop Mode Switches the shop mode
On and Off., page 27).
Please choose your Language
Český
Dansk
Deutsch
English
Español
Francais
Italiano
OK
Language
Please choose the location where your Screeneo
should be placed
Shop
Home
OK
Location