HD9880 User manual
Table of contents Important Electromagnetic fields (EMF) Automatic Shut-Off Recycling Guarantee and Support Declaration of Conformity Software and firmware updates Device compatibility Factory reset Introduction General Overview Description of functions Before first use Preparations before first use Placing the removable mesh bottom Connecting the Airfryer to the NutriU App Using the Airfryer Using the food thermometer Placing the food thermometer M
Important Read this important information document carefully before you use the appliance and save it for future reference. Danger • Do not place the appliance on or near a hot gas stove or all kinds of electric stove and electric cooking plates, or in a heated oven. • Never immerse the appliance in water nor rinse it under the tap. • Do not let any water or other liquid enter the appliance to prevent electric shock.
• • • • • • • • • • • • • • • maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of the reach of children less than 8 years. Do not place the appliance against a wall or against other appliances. Leave at least 10 cm free space at the back, on both sides and above the appliance. Do not place anything on top of the appliance. During hot air frying, hot steam is released through the air outlet openings.
• Always return the appliance to a service center authorised by Philips for examination or repair. Do not attempt to repair the appliance yourself, otherwise the guarantee becomes invalid. • Always unplug the appliance after use. • Let the appliance cool down for approximately 30 minutes before you handle or clean it. • Make sure the ingredients prepared in this appliance come out golden yellow instead of dark or brown. Remove burnt remnants.
Declaration of Conformity Hereby, DAP B.V. declares that the Airfryer HD9880 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.philips.com. The Airfryer HD9880 is equipped with a WiFi module, 2.4GHz 802.11 b/g/n with a maximum output power of 92,9mW EIRP. Software and firmware updates Updating is essential to safeguard your privacy and the proper functioning of your Airfryer and the app.
General Overview D A B c 1 2 3 12 11 4 5 10 9 6 8 7 1. Control panel A. WiFi indicator B. Return button C. Rotary button D. Display 2. Food thermometer socket 3. Drawer 4. Removable mesh bottom 5. Basket with removable mesh bottom 6. Pan 7. Cord storage compartment 8. Air outlets 9. Air inlet 10. Filling level indication 11. Food thermometer 12.
Description of functions Rotary and back button The rotary button is your central control. You can turn and press it to go through different menu options and confirm an action. Short press the rotary button: turn on the appliance. Long press the rotaty button: turn off the appliance. After the appliance is switched on: Press the rotary button: confirm an action. Turn the rotary button: go through different menu options or change the cooking setting. Short press the back button: go back to the previous step.
Cooking time In cooking mode “Manual cooking”, you can set the cooking time from 1 minute to 180 minutes. In cooking mode “Auto-Cook programs”, you do not need to set a cooking time as the Auto-Cook program cooks your food based on your portion sizes or desired doneness level. In cooking mode “Food thermometer”, you do not need to set a cooking time as the cooking is automatically finished as soon the set temperature of the food thermometer is reached.
My programs You can save your favourite Auto-Cook programs, recipe settings or manual cooking settings under “My programs”. Your list can save up to 20 entries. Select an item and start cooking right away. Cooking history You can find your recently cooked items in “Cooking history”. You can see the most recent 20 cooking history entries. Select an item and start cooking right away. Rating functionality You can rate the Auto-Cook programs and all NutriU recipes after cooking.
Before first use 1. 2. 3. 4. Remove all packing material. Remove any stickers or labels (if applicable) from the appliance. Remove the protection foil from the display. Thoroughly clean the appliance before first use (see chapter "cleaning"). Preparations before first use Placing the removable mesh bottom 1. Open the drawer by pulling the handle. 2. Remove the basket by lifting the handle. 3. Insert the removable mesh bottom into the slot on the right bottom side of the basket.
5. Slide the drawer back into the Airfryer by the handle. Note • Never use the pan without the basket. Connecting the Airfryer to the NutriU App Important • Make sure that your smart device is connected to your home WiFi network before you start the WiFi set-up process. 1. Plug in the appliance 2. Press the rotary button to turn on the appliance. Note • When you switch on the appliance for the first time, you will be asked to select the language.
Note • We recommend downloading the NutriU app and add your Airfryer to the app as soon as you set up your appliance for the first time. This enables you to use the Airfryer to its full extent, for example, to enjoy remote cooking (start recipes or Auto-Cook programs from the app, get notifications when food is done, etc.) and to get the latest firmware updates. 7. A QR code displays. Scan it to download the NutriU app. Tip • You can also download the NutriU app from the App Store or from the website www.
Using the Airfryer Caution • This is an Airfryer that works on hot air. Do not fill the pan with oil, frying fat or any other liquid. • Do not touch hot surfaces. Use handles or knobs. Handle the hot pan with oven-safe gloves. • This appliance is for household use only. • This appliance may produce some smoke when you use it for the first time. This is normal. • Preheating of the appliance is not necessary. 1. Place the appliance on a stable, horizontal, level and heat-resistant surface.
5. Put the ingredients in the basket. Note • Do not overfill the basket beyond the "MAX" indication as this could affect the quality of the end result. 6. Slide the drawer back into the Airfryer. 7. Press the rotary button to turn on the appliance. 8. Select the cooking mode you would like to use (see chapter “Cooking Modes”). 9. Follow the steps on the display. The steps vary depending on the chosen cooking mode. Caution • Never use the pan without the basket in it.
Note • Always make sure that your food is fully cooked before serving. • Some Auto-Cook programs notify you when shaking or turning of your food is required. The Airfryer will send out a sound signal when it is time to shake or turn. • The best way to shake is to open the drawer and lift the basket out of the pan and shake it. Then slide the pan with the basket back into the appliance. The appliance will automatically resume cooking.
14. Empty the basket contents into a bowl or onto a plate. Always remove the basket from the pan to empty contents as hot oil may be at the bottom of the pan. Note • To remove large or fragile ingredients, use a pair of tongs to lift out ingredients. • Excess oil or rendered fat from the ingredients is collected on the bottom of the pan.
Note • Make sure the tip of the thermometer is inserted straight into the center of the thickest part of the food, not angled toward the bottom or top of it. Center • Make sure the thermometer is close to but not touching the bone and away from any fat or gristle. • The thickest part of the fillet may not be the center. It is important that the end of the thermometer hits the thickest part so desired results are achieved.
Dos Don'ts Measure the thickness of your food You can use the food thermometer to measure the thickness of your food. 1. Place the food thermometer next to the food and check which marking reaches the top of the food. 2. Set the value from 1 to 6 in the Airfryer when you get asked about the thickness if you cook with an AutoCook program.
Cooking modes Mode How to Auto-Cook Programs Select the Auto-Cook program from the list. Follow the steps on the appliance. The AutoCook programs calculate all cooking parameters automatically based on your input, such as filling level or number of pieces etc. Then start cooking. Manual cooking Set cooking time, temperature and air speed manually and start cooking. Food Thermometer Set core temperature, cooking temperature and air speed manually and start cooking. Auto-Cook Programs 1.
Making home-made fries To make great home-made fries in the Airfryer: • Choose a potato variety suitable for making fries, e.g. fresh, (slightly) floury potatoes. • It is best to air fry the fries in portions of up to filling level 4 for an even result. 1. Peel the potatoes and cut into sticks. Larger fries tend to be less crispy than smaller fries. 2. Soak the potato sticks in a bowl of water for at least 30 minutes. 3. Empty the bowl and dry the potato sticks with a dish towel or paper towel. 4.
3. Adjust the temperature by turning the rotary button. You can choose a temperature from 40°C to 200°C. Confirm by pressing the rotary button. 4. Adjust the air speed by turning the rotary button. You can choose between a high air speed and a low air speed. Confirm by pressing the rotary button. • You then see an overview of the selected cooking parameters. If you want to change a cooking setting, turn the rotary button to the parameter you would like to change. Press and rotate to change the parameter.
The table below gives you a guidance on which core temperature to set.
My programs 1. Turn the rotary button until "My programs" is selected. Press the rotary button to enter this mode. 2. Turn the rotary button to the desired program. If you stay at one program, the cooking parameters pop up. 3. Press the rotary button to enter the selected program. Press the rotary button again to start cooking. • Turn and press the rotary button to either remove the program or to rename it. Cooking history 1. Turn the rotary button until "Cooking history" is selected.
Tip • If food residues stuck to the pan or basket, you can soak them in hot water and dishwashing liquid for 10–15 minutes. Soaking loosens the food residues and makes it easier to remove. Make sure you use a dishwashing liquid that can dissolve oil and grease. If there are grease stains on the pan or basket and you have not been able to remove them with hot water and dishwashing liquid, use a liquid degreaser.
Note • Always hold the Airfryer horizontally when you carry it. Make sure that you also hold the drawer on the front part of the appliance as it can slide out of the appliance if accidentally tilted downwards. This can lead to damaging of the drawer. • Always make sure that the removable parts of the Airfryer e.g. removable mesh bottom, etc. are fixed before you carry and/or store it. Troubleshooting This chapter summarizes the most common problems you could encounter with the appliance.
Problem The Airfryer does not switch on. I see some peeling off spots inside my Airfryer. White smoke comes out of the appliance. Possible cause Solution The amount of ingredients in the basket is too big. Please do not overfill the basket. Certain types of ingredients need to be shaken halfway through the cooking time. The fuller the basket the more frequent shaking is recommended. The appliance is not Check if the plug is inserted in the plugged in. wall outlet properly.
Problem Possible cause The Airfryer is not connected to your The WiFi LED on home WiFi anymore. my Airfryer is not You have changed shining anymore. your home WiFi network. Another user has The App shows that paired the Airfryer the pairing process with a different is not successful. smart device and is currently cooking. 28 English Solution Start the WiFi set up process and follow the instructions in the App.
© 2023 Philips Domestic Appliances Holding B.V.
