HD7832, HD7830
English IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: Read all instructions before using the appliance. 1. Do not touch hot surfaces. Use handles or knobs. Care must be taken to prevent burns which can occur from touching hot parts or spilling hot liquids. 2. To protect against fire, electrical shock and injury to persons, do not immerse cord, plug, or appliance in water or other liquid. 3.
English 17. To prevent scalds and/or property damage, always make sure Coffee Machine lid is securely in place and properly locked before you start using the machine and during brew cycle. Do not force when opening or closing lid. 18. Do not open lid until Coffee Machine has finished brew cycle. Hot steam or hot water trapped under lid cover could burn your fingers. 19. Warning:To reduce the risk of fire or electric shock, do not remove the bottom cover. No user serviceable parts are inside.
English WARNING: - To avoid risk of personal injury or damage to property as a result of overflow, be sure that the cup or mug is centered under the coffee outflow unit during the brew cycle. - Brewed coffee and coffee pods are very hot. Handle with care to avoid scalding. - If coffee coffee spout overflows or fails to drain into cup/mug during brewing cycle, do not open lid or handle coffee spout or coffee pod holder(s). Unplug Coffee Machine and wait for contents to cool before handling.
TABLE OF CONTENTS General description 6 Introduction 7 Preparing the machine for use 7 Brewing coffee 9 Cleaning 13 Descaling 16 Storage 17 Assistance 17 Troubleshooting 18 Warranty 23
1 h I A J B F G K l C M D N E O General description (Fig.
Introduction With Douwe Egberts SENSEO\ coffee pods, you can enjoy a perfect cup of coffee at any time of the day. Every cup is freshly brewed to give you that smooth and full taste. Using more than 250 years of coffee expertise, Douwe Egberts has roasted and ground specially selected coffee beans that, when prepared using a special brewing method co-developed with Philips, ensure a full, smooth taste and delicious foam layer. This joint creation, known as the SENSEO\ coffee pod system, consists of the Ph
2 Fill the water reservoir with cold water up to the MAX indication and put it back onto the machine. 3 Release the lid by moving the lever upwards. 4 Open the lid. 5 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machine without pod(s). 6 Close the lid and lock the lever. Note: Make sure the lever is properly locked by pushing it down until it snaps home with a click. Note: Never flush the machine with the lid open.The lid must be properly locked.
8 Put a bowl (with a capacity of at least 1.6 qt./ 1.5 litres) under the spout openings to collect the water. ) 9 Press the on/off button 3. After pressing the on/off button 3, the display lights up for a moment and the light rings around the 1-cup button q and the 2-cup button qq/w burn continuously. 10 Press the 1-cup button q AND the 2-cup button qq/w briefly at the same time. , The boiler fills itself with water from the water reservoir. This may take some time (approx. 90 to 150 seconds).
2 Press the on/off button 3. , The indicator light blinks slowly and the display shows the heat-up indication D while the water is heating up. Heating up takes approx. 90 seconds. , The coffee machine is ready for use when the indicator light burns continuously and the light rings around the 1- cup button q and the 2-cup button qq/w go on.
, If you want to make two cups of SENSEO\ coffee, use 2 coffee pods in combination with the deeper 2-cup pod holder qq and the 2-cup button qq/w. 6 Place the SENSEO\ coffee pod(s) properly in the center of the pod holder, with the flat SENSEO\ side up and the rounded side facing down. Note: Use SENSEO\ coffee pods from Douwe Egberts specially designed for your SENSEO\ coffee machine for a full and round taste.
, Select 1 bar for a 3 oz. cup or a 6 oz. mug of coffee. , Select 2 bars for a 4 oz. cup or a 8 oz. mug of coffee. , Select 3 bars for a 5 oz. cup or a 10 oz. mug of coffee. 10 Press the button indicating the number of cups of SENSEO\ coffee you want to brew. - Press the 1-cup button q for one cup. - Press the 2-cup button qq/w for two cups or one mug.
machine, you have not flushed the machine properly before first use. As a result, the boiler is not or not completely filled. Flush the machine properly (see chapter ‘Preparing the machine for use’) before you brew another cup of coffee. 11 Remove the coffee pod(s) after use by lifting the pod holder out of the machine and emptying it. Be careful when doing this, for there may still be some hot water/coffee on the coffee pod(s) or steam may escape.
5 Clean the coffee spout, the coffee collector and the drip tray in hot water, if necessary with some dish soap, or in the dishwasher. 6 Hold the cup tray in your hand while cleaning it with hot water, if necessary with some dish soap. The cup tray can also be cleaned in the dishwasher. To clean the cup tray, always remove it from the machine, as it might prove sharp when handled incorrectly. Always handle it carefully.
11 Clean the water distribution disc with a moist cloth. Be careful when you do this; make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc. If it does, the coffee machine will start leaking! Flushing If you have not used the coffee machine for three days, you have to flush it with fresh water before you use it again.
Descaling When to descale Descale the SENSEO\ coffee machine frequently! Preferably descale 4 to 6 times a year, but at least once every 3 months. Descaling takes about 1 hour. Do not interrupt the descaling process. After you have brewed 500 cups, the CALC CLEAN indication appears on the display. Always descale when this indication appears. , After you have brewed another 8 cups, the CALC CLEAN indication disappears from the display, whether or not you have performed the descaling procedure.
3 Press the on/off button 3. The machine is ready for use when the indicator light burns continuously. 4 Place the 1-cup holder q with a used coffee pod in it in the coffee machine. Close the lid and make sure it is properly locked. Note: Always put a used coffee pod in the pod holder when you descale the machine.This pod serves as a ‘filter’ to prevent the sieve in the pod holder from getting clogged with scale residue. 5 Put a bowl with a capacity of at least 1.6 qt./1.
Troubleshooting If you have a problem, you may find the solution in the table below. If the table does not provide the solution to your problem or if you have a question, see chapter ‘Assistance’. Problem Solution The indicator light continues You have not yet flushed the coffee machine (see chapter ‘Preparing the to blink slowly. machine for use’). You have used the SENSEO® coffee machine at an altitude higher than 6800 Ft. / 2200 m above sea level.
Problem Solution the water drops on the worktop are not the result of placing or removing the water reservoir or removing used coffee pods; you do not remove the water reservoir when the coffee machine is heating up. This may cause water that normally ends up in the water reservoir to leak out of the machine. In all other cases, contact the Philips Consumer Care Centre in your country. The coffee spout cannot be taken out of the machine.
Problem Solution you have used the correct number of pods and have pressed the right button. Use 1 pod in combination with the 1-cup pod holder q and the 1- cup button q. Use 2 pods in combination with the 2-cup pod holder qq and the 2-cup button qq/w. the coffee pod(s) have been placed properly in the centre of the pod holder, to prevent water from escaping along the edge of the pod(s).
FULL TWO YEARS WARRANTY Philips Electronics North America Corporation warrants each new Philips Product, model HD7832/7830 (except cord, coffee pods and accessories) against defects in materials or workmanship for a period of two years from the date of purchase, and agrees to repair or replace any defective product without charge.
4222.200.0008.
