Quick start guide GC9930 Congratulations on your purchase of the Wardrobe Care System and welcome to Philips! We hope you will enjoy the usage of this system. To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
Exploded view A General description A Hanger hook B Refreshing button B C C Air vents D D Air vent slide E E NeverBurn ironing board cover F Fan G Board handle F H Board tilting button I Height adjustment lever J Locking strap G S R H I K Iron compartment J L Iron M Mains plug Q P N Rinse tray O Water tank O P Water tank release button Q Power-on light and Auto CalcClean light R Steamer compartment N S Steamer K L M
1 Ironing T Steam activator U Iron power-on button with light V Blowing/suction button D Air vent slide I Height adjustment lever H Board tilting button J Locking strap M Mains plug T U V I D H J M EEIroning tips and tricks • To iron shirts, use the wide end of the board to save time and energy. • To avoid shine and seam imprints, use the blowing mode. To hold the garment flat on the board, use the suction mode. 1 Put the mains plug M in an earthed wall socket. The power-on light goes on.
2 Steaming A Hanger hook D Air vent slide U Steamer power-on button with light V Blowing/suction button T Steam activator H Board tilting button I Height adjustment lever J Locking strap M Mains plug A D U V T H I J M EESteaming tips and tricks • The steamer is perfect for all delicate fabrics, such as silk, wool and cashmere. • To steam a jacket, put it directly on the board. To steam a blouse or a dress, use the hanger hook A. 1 Put the mains plug M in an earthed wall socket.
3 Refreshing B Refreshing button C Air vent D Air vent slide H Board tilting button I Height adjustment lever J Locking strap M Mains plug B C D H I J EERefreshing tips and tricks • Perfect to remove food or cigarette smoke smells from jackets, coats and sweaters. • Combine the refreshing mode with the steaming mode to refresh garments and remove creases at the same time. 1 Put the mains plug M in an earthed wall socket. The power-on light goes on.
Auto CalcClean Note: The Auto CalcClean process is automatically activated at intervals of approximately 3-5 tanks of water used. Note: O nce the Auto CalcClean process is activated, it cannot be stopped or skipped.
Frequently asked questions This chapter lists the questions most frequently asked about the appliance. If you cannot find the answer to your question, contact the Consumer Care Centre in your country. Question Answer Why does the system keep beeping and flashing? If the blue Auto CalcClean light flashes, the Auto CalcClean process may be in process. It takes about 3 minutes to complete. If the red light at the bottom rinse tray flashes, empty the rinse tray and put it back.
Important Read this user manual carefully before you use the appliance and save it for future reference. Danger ,, Never immerse the iron, the steamer or the appliance in water. Warning ,, Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. ,, Do not use the appliance if the plug, the mains cord, the supply hoses or the appliance itself shows visible damage, or if the appliance has been dropped or is leaking.
