User Manual
Table Of Contents
16
ENGLISH
Problem Solution
The iron leaves
a shine or an
imprint on the
garment.
The surface to be ironed was
you were ironing over a seam
or a fold in the garment.
PerfectCare is safe on all garments. The
shine or imprint is not permanent and
you can place a cotton cloth over the
area to be ironed to avoid imprints at
seams and folds.
The appliance
does not produce
any steam.
There is not enough water
in the water tank (the ‘water
Fill the water tank (see chapter ‘Using
water tank’).
The appliance is not hot
enough to produce steam.
Wait until the ‘iron ready’ light on the
iron lights up continuously.
trigger.
Press the steam trigger and keep it
pressed while you iron.
The water tank is not placed
in the appliance properly.
Slide the water tank back into the
The appliance is not switched
on.
Insert the plug in the wall socket and
the appliance.
The appliance has
activated automatically
when the appliance has not
been used for more than 10
minutes.
switch on the appliance again.
The appliance
produces a
pumping sound.
Water is pumped into the
boiler inside the appliance.
This is normal.
If the pumping sound continues
remove the plug from the wall socket.
Contact an authorised Philips service
centre.