User Manual
Table Of Contents
10
ENGLISH
7 KeeptheEASYDE-CALCopeningfacingup,reinserttheEASYDE-CALCknobandturn
itclockwisetofastenit(Fig.18).
8 Puttheappliancebackonastableandevensurface.Plugintheapplianceandswitch
iton(Fig.19).
9Waitfor5minutesfortheappliancetoheatup.
10Keepthesteamtriggerpressedcontinuouslywhileyoumovetheirononapieceof
thickclothfor3minutes(Fig.20).
Warning: hot, dirty water comes out of the soleplate.
11 Stopmovingtheironwhennomorewatercomesoutorwhensteamstartscoming
out.
12 Youcancontinuetousetheapplianceimmediately.Otherwiseunplugtheappliance
afterthedescalingiscompleted.
Troubleshooting
This chapter summarises the most common problems you could encounter with the
www.philips.com/support
Care Centre in your country.
Problem Possible cause Solution
The ironing board
cover becomes
wet or there are
water droplets
on the garment
during ironing.
Steam has condensed on the
ironing board cover after a
long ironing session.
Replace the ironing board cover if the
also add an extra layer of felt material
under the ironing board cover to
prevent condensation on the ironing
cover that is not designed to
cope with the high steam rate
of the appliance.
Put an extra layer of felt material under
the ironing board cover to prevent
condensation on the ironing board.
Water droplets
come out of the
soleplate.
The steam that was still
present in the hose has
cooled down and condensed
into water. This causes water
droplets to come out of the
soleplate.
Steam away from the garment for a
few seconds.
Steam and/or
water come out
from under the
knob.
not tightened properly.
appliance cool down for 2 hours.
and screw it back onto the appliance
properly. Note: Some water may
escape when you remove the knob.
The rubber sealing ring of the
Contact an authorised Philips service