operation manual

4 RemovetheEASYDE-CALCknobandletthewaterwithscaleparticlesow
into the cup (Fig. 2).
5 Whennomorewatercomesoutoftheappliance,reinserttheEASYDE-CALC
knob and turn it clockwise to fasten it. (Fig. 20)
Storage
1 Switchofftheapplianceandunplugit.
2 Remove the water tank and empty it.
3 Put the iron on the iron platform. Push the carry lock to lock the iron onto the platform.
4 Fold the supply hose and mains cord. Put them in their respective storage
compartments. (Fig. 21)
5 Youcancarrytheappliancewithonehandbythehandleoftheiron.
Do not carry the appliance by holding the water tank release lever.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The ironing board
cover becomes
wet or there are
water droplets on
the garment
during ironing.
Steam has condensed on the
ironing board cover after a long
ironing session.
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
board cover to prevent condensation on
the ironing board. You can buy felt
in a fabric shop.
You have an ironing board
cover that is not designed to
cope with the high steam rate
of the appliance.
Put an extra layer of felt material under
the ironing board cover to prevent
condensation on the ironing board.
You can buy felt in a fabric shop.
Water droplets
come out of the
soleplate.
The steam that was still present
in the hose has cooled down
and condensed into water. This
causes water droplets to come
out of the soleplate.
Steam away from the garment for
a few seconds.
Steam and/or
water come out
from under the
EASY DE-CALC
knob.
The EASY DE-CALC knob is
not tightened properly.
Switch off the appliance and let the
appliance cool down for 2 hours. Unscrew
the EASY DE-CALC knob and screw it
back onto the appliance properly. Note:
Some water may escape when you remove
the knob.
The rubber sealing ring of the
EASY DE-CALC knob is worn.
Contact an authorised Philips service
centre for a new EASY DE-CALC knob.
ENGLISH 9