User Guide

Energy saving

Eco mode

By using the ECO mode (reduced amount of steam), you can save energy without compromising on the

ironing result.

1 To activate the ECO mode, press the ECO button (Fig. 15). The green ECO light goes on.

2 To deactivate the ECO mode, press the ECO button again. The green ECO light goes out.

Autoshut-o

- To save energy, the appliance switches o automatically when it has not been used for 10 minutes. The

light in the on/o button starts to ash.

- To activate the appliance again, press the on/o button. The appliance then starts to heat up again.

Warning: Never leave the appliance unattended when it is connected to the mains. Always unplug

the appliance after use.

Cleaning and maintenance

Descaling the appliance

Perform the descaling procedure when the EASY DE-CALC light starts to ash (Fig. 16). This helps to prolong

the lifetime of the appliance and optimizes the ironing performance.

Note: If your water is hard, increase the descaling frequency.

Warning: To avoid the risk of burns, unplug the appliance and let it cool down for at least two hours

before you perform the descaling procedure (Fig. 17).

Tip: When you perform the descaling procedure, place the appliance on the edge of the table top or near

the sink. Water may ow out of the appliance when the EASY DE-CALC knob is being opened.

1 Hold a cup (with a capacity of at least 350 ml) under the EASY DE-CALC knob and turn the knob anti-

clockwise. Remove the EASY DE-CALC knob and let the water with scale particles ow into the cup.

(Fig.18)

2 When no more water comes out of the appliance, reinsert the EASY DE-CALC knob and tighten it

(Fig.19).

Descaling the soleplate

If you do not descale your appliance regularly, you may see brown stains coming out of the soleplate due

to scale particles. Descale the soleplate by following the procedure below. We advise you to perform the

procedure twice for better results.

1 Make sure the appliance is cool and clean the soleplate with a damp cloth.

2 Empty the water tank through the lling door (Fig. 20). Tilt the appliance and remove the EASY DE-CALC

knob.

3 Pour 500ml distilled water into the DE-CALC opening and tighten the EASY DE-CALC knob (Fig. 21).

4 Fill up the water tank halfway. Switch on the appliance and wait for 5 minutes.

5 Keep the steam trigger pressed continuously while you iron a few pieces of thick cloth in a back-and-

forth motion for 3 minutes (Fig. 22).

Warning:Hot,dirtywater(about100-150ml)comesoutofthesoleplate.

6 Stop cleaning when no more water comes out of the soleplate or when steam starts coming out of the

soleplate.

7 Unplug the steam generator and let it cool down for at least two hours. Remove the EASY DE-CALC knob

and let the remaining water ow out. Tighten the EASY DE-CALC knob.

English