User Guide

10
Problem Cause Solution
The ironing board cover
becomes wet, or there
are water droplets on the
oor/garment.
Your board cover is not designed
to cope with the high steam rate.
Use a layer of felt material in the board
cover to prevent water droplets.
The surface under the base
of the appliance becomes
wet, or steam and/or
water comes out from
under the EASY DECALC
knob.
The EASY DECALC knob is not
tightened properly.
Switch o the appliance and wait 2
hours for it to cool down. Unscrew and
reattach the knob to make sure it is
tightened.
The rubber sealing ring of the
EASY DECALC knob is worn.
Contact an authorized Philips service
center for a new EASY DECALC knob.
The iron does not heat up
and the amber DECALC
light ashes.
The appliance reminds you
to perform the descaling
procedure. The light ashes after
approximately one month of use.
Perform the descaling procedure,
following the instructions in section
‘Descaling the appliance’.
Warranty and support
If you need information or support, please visit www.philips.com/support or read the international
warranty leaet.
English