User Guide
Table Of Contents
9
Storage
1
Note: it is recommended to empty the water tank after every use.
2
3
4 Fold the mains cord and fasten it with the Velcro strip.
5
platform.
Troubleshooting
www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The iron does not produce
any steam.
There is not enough water in
the water tank.
Fill the water tank. Press and hold the steam
trigger until steam comes out. It may take up
to 30 seconds until steam comes out.
You did not press the steam
trigger.
Press and hold the steam trigger until steam
comes out.
The steam function has
performed the Calc-Clean
process.
Perform the Calc-Clean process to restore the
steam function. (see chapter ‘Cleaning and
maintenance’)
At the start of your ironing
enough.
Press and hold the steam trigger until steam
comes out. It may take up to 30 seconds until
steam comes out.
No steam comes out of
You have not done or have
not completed the Calc-
Clean process.
steam function again (see chapter ‘Cleaning
and maintenance’).
Water droplets come out
of the soleplate.
After the Calc-Clean process
remaining water may drip
out of the soleplate.
Wipe the soleplate dry with a piece of cloth.
Clean process (see chapter ‘Cleaning and
maintenance’).
You have used the steam
frequently.
The Calc-Clean process has
You have to perform the Calc-Clean
process again (see chapter ‘Cleaning and
maintenance’).
Steam condenses into water
in the hose when you use
have not used it for a long
time.
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of the
soleplate.
English