User Guide

9
Storage
1 Switch o the appliance and unplug it.
Note: it is recommended to empty the water tank after every use.
2 Place the iron on the iron platform and lock it by pushing the carry lock release button )Fig. 22(.
3 Fold the supply hose and wind the supply hose inside the supply hose storage compartment )Fig.23(.
4 Fold the mains cord and fasten it with the Velcro strip.
5 You can carry the appliance with one hand by the handle of the iron when the iron is locked on the iron
platform.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you are
unable to solve the problem with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The iron does not produce
any steam.
There is not enough water in
the water tank.
Fill the water tank. Press and hold the
steam trigger until steam comes out. It may
take up to 30 seconds until steam comes
out.
You did not press the steam
trigger.
Press and hold the steam trigger until
steam comes out.
The steam function has
been disabled until you have
performed the Calc-Clean
process.
Perform the Calc-Clean process to restore
the steam function. )see chapter ‘Cleaning
and maintenance’)
At the start of your ironing
session, the steam trigger has
not been pressed long enough.
Press and hold the steam trigger until
steam comes out. It may take up to 30
seconds until steam comes out.
No steam comes out of
the soleplate, the light of
the CALC CLEAN button
ashes and the appliance
beeps.
You have not done or have
not completed the Calc-Clean
process.
Perform the Calc-Clean process to enable
the steam function again )see chapter
‘Cleaning and maintenance’).
Water droplets come out
of the soleplate.
After the Calc-Clean process
remaining water may drip out
of the soleplate.
Wipe the soleplate dry with a piece of
cloth. If the Calc-Clean light still ashes and
the appliance still beeps, perform the Calc-
Clean process (see chapter ‘Cleaning and
maintenance’).
You have used the steam boost
function too frequently.
Use the steam boost function only for
stubborn creases. It is recommended not
to use it for more than 5 times within 3
minutes.
The Calc-Clean process has not
been completed.
You have to perform the Calc-Clean
process again (see chapter ‘Cleaning and
maintenance’).
Steam condenses into water in
the hose when you use steam
for the rst time or have not
used it for a long time.
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of
the soleplate.
English