Owner's Manual

Problem Possible cause Solution
The iron does not
produce steam.
When you use the iron in
cordless mode, it cools down
after a while. It needs to
reheat on the stand regularly.
Put the iron back onto the stand until the
temperature light goes out to indicate that the
iron is ready for use again.
The iron does not
produce steam.
The steam control is set to
the ‘no steam’ setting (0).
Set the steam control to a steam setting (1-6).
The water tank is empty. Fill the water tank.
The iron leaks. The water tank is overlled. Do not ll the water tank beyond the MAX
indication.
Water leaks out of
the soleplate when I
ll it with water.
The steam control is set to a
steam setting (1-6) when you
ll the water tank.
Set the steam control to 0 (= no steam) when
you ll the water tank.
The shot-of-steam
function does not
work properly.
You have used the shot-of-
steam function too often
within a very short period.
Put the iron back onto the stand until the
temperature light goes out to indicate that
the iron is ready for use again. Always set the
temperature dial to 3 or MAX when you
use the shot-of-steam function.
Flakes and impurities
come out of the
soleplate during
ironing.
Hard tap water causes
akes to develop inside the
soleplate.
Use the shot-of-steam function repeatedly to
remove akes and scale from the soleplate. We
advise you to use demineralised water if the tap
water in your area is too hard. You can also use
the Calc-Clean function.
ENGLISH18