User Manual

Problem Possible cause Solution
The temperature light ashes
red (GC3360 only).
The automatic shut-off function
has switched off the iron (see
chapter ‘Features’).
Move the iron slightly to deactivate
the automatic shut-off function.
The red auto-off indication of the
temperature light goes out.
Water drips from the
soleplate after the iron has
cooled down or has been
stored (GC3321/GC3320
only)
You have put the iron in
horizontal position while there
was still water in the water
tank.
Always set the steam control to
position 0 and empty the water tank
after use. Store the iron on its heel.
The iron does not produce a
steam boost.
You used the steam boost
function too often within a
short period.
Continue ironing in horizontal
position and wait a while before you
use the steam boost function again..
The iron is not hot enough. Set an ironing temperature at which
the steam boost function can be
used (temperature settings 2 to
MAX). Put the iron on its heel and
wait until the amber temperature
light goes out before you use the
steam boost function.
4239.000.6909.1
4/11