Specifications

10 EN
Connect power
Caution
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage set on the voltage
selector on the bottom panel of the unit.
• Ensure that the power supply socket used can
support at least 10A current loading.
• Before connecting the AC power cord, ensure that you
have completed all other connections.
1 If your power supply voltage is 110V-127V,
adjust the voltage selector (locate on the
bottom panel of the unit) to 110V-127V.
2 Connect the AC power cable to the wall
socket.
$17(11$
0
$0
'2&.
68%
:22)(5

6 ($.(56 
3&,1 $8;
5
/
Prepare the remote control
Note
•
Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Danger of explosion if battery is incorrectly replaced.
Replaceonlywiththesameorequivalenttype.
1 Open the battery compartment.
2 Insert two AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
• Do not use old and new or different types of batteries
in combination.
• Batteries contain chemical substances, so they should
be disposed of properly.
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to the power supply.
» [AUTO INSTALL - PRESS PLAY] (auto
install - press the PLAY button) is
displayed.
2 Press on the main unit to start
installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
stationswithsufcientsignalstrength.