FWM377 Mini Hi-Fi System pg001-033_FWM377_55_Eng 1 2007.1.
México Es necesario que lea cuidadosamente su instructivo de manejo. PRECAUCIÓN - ADVERTENCIA No abrir, riesgo de choque eléctrico ATENCIÓN Verifique que el voltaje de alimentación sea el requerido para su aparato Para evitar el riesgo de choque eléctrico, no quite la tapa. En caso de requerir servicio, dirijase al personal calificado. Descripción: Modelo : Alimentación: Consumo: Importador: Domicilio: Minisistema de Audio FWM377/55 110–127 / 220–240 V; ~50/60 Hz 120 W Philips Mexicana, S.A. de C.V. Av.
8 * 2 3 1 7 º 4 ^ @ % 9 § $ ª ! & 3 pg001-033_FWM377_55_Eng 3 2007.1.
(for tuner installation) 4 pg001-033_FWM377_55_Eng 4 2007.1.
English Index Português English ------------------------------------------------ 6 Español Español --------------------------------------------- 67 5 pg001-033_FWM377_55_Eng 5 2007.1.
Contents English General Information Radio Reception Supplied accessories ............................................ Environmental information ................................ Safety information ................................................ Hearing Safety ....................................................... 7 7 7 8 Preparations Rear connections .......................................... 9~10 Power Antennas connection Speakers connection Optional connection .....................................
● Don’t expose the system to dripping or splashing. ● Install this unit near the AC outlet and where the AC power plug can be reached easily. Supplied accessories – – – – 2 speaker boxes remote control MW loop antenna FM wire antenna Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
General Information English Hearing Safety Listen at a moderate volume. ● Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss. ● Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc.
English Preparations FM antenna MW antenna B Speaker (right) Speaker (left) AM ANTENNA FM ANTENNA AUX/CDR R L LOW CH – + L R L R HIGH CH SPEAKERS 6Ω C A AC power cord Rear connections The type plate is located at the rear of the system. automatically under extreme conditions. If this happens, let the system cool down before reusing it (not available for all versions).
Preparations English FM Antenna Optional connection The optional equipment and connecting cords are not supplied. Refer to the operating instructions of the connected equipment for details. Connecting a USB device or memory card ● For better FM stereo reception, connect an outdoor FM antenna to the FM ANTENNA terminal.
English Preparations Inserting batteries into the remote control Insert two batteries (Type R06 or AA) into the remote control with the correct polarity as indicated by the "+" and "-" symbols inside the battery compartment. CAUTION! – Remove batteries if they are exhausted or will not be used for a long time. – Do not use old and new or different types of batteries in combination. – Batteries contain chemical substances, so they should be disposed of properly. 11 pg001-033_FWM377_55_Eng 11 2007.1.
Controls (main set illustrations on page 3) English – AUX•TAPE (on the system only) to switch between AUX and tape sources. – USB to select USB source. 1 3 iR SENSOR 2 – º infrared sensor for remote control. ⁄ 4 MASTER VOLUME (VOL +/-) 4 – to increase or decrease the volume. 5 DBB – ! to select the desired bass boost level. (DBB 1, DBB 2, DBB 3 or DBB OFF). 6 DSC – Selects different types of preset sound equaliser settings (OPTIMAL, TECHNO, ROCK or JAZZ).
STOP Ç for CD/ MP3-CD/WMA to stop playback or to clear a programme. for Tuner ..................... (on the system only) to stop programming. for Demo ................... (on the system only) to activate/deactivate the demonstration. for Clock .................... to exit clock setting. for Plug&Play ............ (on the system only) to exit plug&play mode. PLAY•PAUSE ÉÅ for CD/ MP3-CD/WMA to star t or interrupt playback. PRESETí/ë ( TITLE -/+) for MP3-CD/WMA to select previous/next title. for CD ..........
Basic Functions English IMPORTANT! Before you operate the system, complete the preparation procedures. 2 Plug and Play (for tuner installlation) To exit without storing the Plug and Play ● Press Çon the system. ➜ If you do not complete the Plug and Play installation, the function will be restar ted when you next turn on the main supply again. Plug and Play allows you to store all available radio stations automatically.
Demonstration mode The system has a demonstration mode that shows the various features offered by the system. English Basic Functions DIM 3 or DIM OFF display mode. ➜ DIM is shown, except for DIM OFF mode. To activate the demonstration ● In standby mode, press and hold STOPÇ on the system for 5 seconds to switch to demonstration. To deactivate the demonstration ● Press and hold STOPÇ on the system for 5 seconds to switch to standby mode. Volume control Switching the system on ● Press STANDBY-ON 2.
Basic Functions English Automatic DSC-DBB selection The best DBB setting is generated automatically for each DSC selection. You can manually select the DBB setting that best suits your listening environment. Sound control For optimal sound listening, select only one of the following navigation sound controls at a time : MAX or DSC. MAX Sound MAX sound provides the best mixture of various sound features (DSC, DBB, for example). ● Press MAX SOUND (or MAX on the remote control) repeatedly.
English CD/MP3-CD/WMA Operations IMPORTANT! – This system is designed for regular discs. Therefore, do not use any accessories such as disc stabiliser rings or disc treatment sheets, etc., as offered on the market, because they may jam the changer mechanism. – Do not load more than one disc into each tray. About MP3 disc Supported formats – ISO9660, Joliet, Multisession – Max. track number plus album is 512 – The max.
CD/MP3-CD/WMA Operations English 3 Press OPEN•CLOSE to close the disc tray. ➜ READING is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time (or the total number of albums and tracks for MP3/WMA disc) are shown. Text display during playback In CD mode ● Press DISPLAY to show the current track number and remaining playback time. In MP3-CD/WMA mode Notes: – Load the discs with the label side facing up.
Different play modes: SHUFFLE and REPEAT You can select and change the various play modes before or during playback. The play modes can also be combined with PROGRAMME. SHUF ................ tracks of the entire disc are played in random order SHUF REP ALL…repeats the entire disc continuously in random order REP ALL ........... repeats the entire disc/ programme REP ...................
Radio Reception English ➜ If a radio station has been stored in one of the presets, it will not be stored again under another preset number. Tuning to radio stations 1 2 3 4 Press TUNER to select TUNER mode. ➜ "FM" or “MW” is displayed. A few seconds later, the current radio frequency will appear on the display. Press TUNER again to select the desired waveband : FM or MW. Press and hold à or á until the frequency indication starts to change, then release.
English Radio Reception Manual Preset Programming 1 2 Tune to your desired radio station (refer to “Tuning to radio stations”). Press PROGR on the remote control. ➜ PROG starts flashing. ➜ The next available preset number is displayed for selection. To store the radio station to another preset number ● Press í or ë to select the desired preset number. 3 Press PROG again to store the radio station. ➜ PROG disappears. ● Repeat steps 1–3 to store other radio stations.
Tape Operation/Recording English IMPORTANT! – Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism. – C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system. – Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a transformer,TV or speaker). Tape playback 1 2 3 5 Press PLAY 2 to start playback.
General information on recording ● If you do not intend to record via the microphone, unplug the microphone to avoid accidental mixing with other recording source. ● Recording is permissible insofar as copyright or other rights of third par ties are not infringed. ● For recording, use only NORMAL (IEC type I) tapes on which the tabs have not yet been broken. This deck is not suited for recording on METAL (IEC IV) type tapes.
Tape Operation/Recording English Maintenance Cleaning the Cabinet ● Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives. Cleaning Discs ● When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out. ● Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records.
Using a non-USB device 1 2 Connect the audio out terminals of the external equipment (TV, VCR, Laser Disc player, DVD player or CD Recorder) to the AUX terminals of your system. Press AUX•TAPE once (or press AUX on the remote control) to select external equipment. Note: – All the sound control features (DSC or DBB, for example) are available for selection. – Refer to the operating instructions for the connected equipment for details.
External Sources English How to organize your MP3/WMA files on the USB mass storage device This Hi-Fi system will browse the MP3/WMA files in the folders/sub-folders/titles order. Example: Root Title 001 Title 002 Title 003 Album 01 Title 001 Title 002 Title 003 Album 02 Title 001 Title 002 Title 003 Album 03 Title 001 Title 002 Title 003 Organize your MP3/WMA files in different folders or subfolders as required.
Ripping function Notes: – This function can also be combined with the programme function. In this case, selection of "RIPPING ALL" in DISC mode will record all programmed tracks from the starting point to the USB mass storage device. – It is impossible to rip from "MIC IN". – Never unplug the USB mass storage device before pressing STOP9 to stop ripping.
External Sources English Tuner record timer setting Notes: – It is impossible to set a sleep timer more than 12 hours later than the start timer. – During timer setting, if no button is pressed within 60 seconds, the system will exit timer setting mode automatically. This function enables you to set a timer for starting and stopping ripping from the tuner source automatically. IMPORTANT! – Before setting the timer, ensure that the clock is set correctly.
English Clock/Timer 1 2 3 4 Clock setting Timer setting The system only supports 24-hour time mode. The system can switch on to CD, TUNER or USB mode automatically at a preset time, serving as an alarm to wake you up. In standby or view clock mode, press CLOCK•TIMER on the remote control once. In other source mode, press CLOCK•TIMER twice. IMPORTANT! – Before setting the timer, ensure that the clock is set correctly. Press à or á repeatedly to set the hour.
Clock/Timer English 4 5 Press í or ë repeatedly to set the minute for the timer to start. Press CLOCK•TIMER to store the start time. ● At the preset time, the selected source will play. To exit without storing the setting ● Press STOP Ç on the system. Notes: – When the preset time is reached and the selected disc tray is empty, the next available disc will be selected. If all the disc trays are not available,Tuner will be selected automatically.
AMPLIFIER RMS output power 1KHz (Low channel-both channels driven) ....... ............................................................. 60 W per channel 10KHz (High channel-both channels driven) .... ............................................................. 60 W per channel Total output power ........................................... 240 W Signal-to-noise ratio .......................... 67 dB A (IEC) Frequency response .......................... 50 – 16000 Hz Input sensitivity AUX ..................
Troubleshooting English WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help. Problem Solution “NO DISC” is displayed. ✔ Insert a disc. ✔ Check if the disc is inserted upside down.
The remote control does not function properly. ✔ Select the source (CD or TUNER, for example) before pressing the function button (É,í,ë). ✔ Reduce the distance between the remote control and the system. ✔ Insert the batteries with their polarities (+/– signs) aligned as indicated. ✔ Replace the batteries. ✔ Point the remote control directly towards the IR sensor. ✔ Set the clock correctly. ✔ Press and hold TIMER ON/OFF to switch on the The time is not working. timer.
