CONTENTS General Information Safety Information Preparation .. Controls Operating the system.. Recording Clock / Timer Specifications. Maintenance Troubleshooting..
GENERAL INFORMATION SAFETY INFORMATION General Information * The type plate (which contains the serial numeric} is located at the rear of the system. = Recording is permissible i copyright or other rights of third parties are avt infringed. * This product complies with the radio interference requirements of the European Community. Environmental Information Al unnecessary packaging material has bean omitted.
AM Antenna Connection Connect the supplied Loop arena to the AM AERIAL terminal, Place the AM loop antenna far away from the System and adjust its position for the best reception, @ FM Wire Antenna Connection Conn est the supplied FM quite antenna to the FM 75 Q. terminal, Adjust the position of the M antenna for the ‘best reception.
CONTROLS Controls on the system and remote contra (i) Standbys On ~ to switch the system on of to standby mode. ~ o sorta radio stations automatically by pressing and holding for 2 seconds font in Standby or Demonstration mode} {3) RECORD o start recording on tape deck 2 only, {3) REVERSE MODE o select the different playback mode on tape desk 2 only, 141 CLOCKS TIMER ~ 10 view clock, set clock of timer. (8] NEWS to hear news at 4 preset time automatically. 1§} ADS =t select RDS data.
b OPERATING THE SYSTEM Important: Before you begin aerating the system, complete the preparation procedures, Demonstration mode ‘The system has a demonstration mode that shows the various features offered by the shyster. Whereas the system is switched on farm the wall socket, the demonstration mode will start automatically. During demonstration mods, if you press any secure for standby-on} bunion, the System will switch ta the respective for standby) made.
cD Warning! 1) This system is designed for conventional CUs. Do not use any accessories like dies stabilizer tings o7 €O treatment sheets, etc., which may damage the CO mechanism. 2} Do not load mots than ane dies into each tray. / discovery 3 When the €D changer is goaded with CD{s), do Aot turn over or shake the system. This may jem = 2 7 the changer, [ = ase Yau can Pad up to three discs in the CD changer TSR RO ] for continuous playback without interruption.
3 €D Direct Play * Toucan play a 0D directly by pressing the freestanding 3 €D DIRECT PLAY {1 3) button. The CD player will stop at the end of playback of the selected ise, ~ When the button is lighted, it indicates that there is @ dies located in the dies tray. Playing a €D 1 Cross PLAY P o start playback, = The dies tray, wack number and elapsed playing tim of the current track appear on the display. ~ Thg LED on the respective 3 OO Direct Play button will be fishing.
cp = During programming. If o button Is pressed within 20 e seconds, the system will exit program mode automatically Playing the program 1 Press PLAY » 1o start program playback, "PALS PRO GRAIN will be displayed. The track number and elapsed playing time of the current track will appear on tha display. i you press REPEAT during program playback, the current track will be played repeatedly, — The REPEAT and FROGMAN flags will be displayed. 2 Press STOP ® 1o stop program playback.
Easy Set only in Stands or Demonstration mode] * When searching RS station; EASY SET allows you to store ol available radio stations and RS stations in a particular band (MWL) automatically. 1 Press and hold STANDBY.ON fon the system any] for 2 seconds. = "CRAY SET” will be displayed and followed by THINNER Easy set wilt start with the last active bend. All equitable radio stations with sufficient signal strength will be stored or uni! 40 presets are filled.
ii TUNER Storing Preset Radio Stations You ¢an store up to 40 radio stations in the memory. Wi a preset radio station Is selected, the preset umbra appears next to the frequency on the display. Automatic programming Crass TUNER. Tress TUNER (BAND) again to select the desired evenhanded Press PROGRAM for some than pne second, ~ PROGRAM flag starts trashing and “ATE villi be displayed. — Vary available radio station wilt be stored automatically. The frequency and preset number will be displayed brie thy.
Receiving RDS radio station &8 ROS {Ratio Data System} is o broadcasting service that allies FM stations to send additions! information along with the regular P radio signal, This additional information can contain: + STATION NAME: This station name is displayed. + FREQUENCY: The frequency of the station is displayed. * PROGRAM TYPE: The following program types eds and can be received by your tuner: News, Affairs, Info, $port, Educate, Drama, Culture, Science, Varied, Pop 14, Rack M, M.O R.
TAPE TAPE 2 o | Loading a tape * Crass OPEN. * The tape deck door apes. « Load the tape with the pane side downward and the full spool to the deft. « Close the tape deck door. Tape Playback 1 Press TAPE to select TAPE mode. ~TAPE For TAPE 2 bill be splayed « Press TAPE again to select either tape deck 1 or tape deck 2, 2 Load the tape into the desired tape deck. 3 Press PLAY & 1o start playback.
TAPE Auto Reverse Playback forenoon tape deck 2) Notes: = Pies REVERSE MODE to select the different playback modes. . recording or playback on one SIDS of the tape. The taps sips at the end of one side. . recording oF playback on both sides of the tape. The taps then spats. . Continuous playback on both sides of the tape up 10 & maximum of 20 times par side unless you press STOP I, Rewind/Fast Forward font on tape deck 2) At the stop mode You can rewind or fast forward the tape by pressing <40 respectively.
RECORDING Notes: ~ For recording, use only tape of IEC type 1 formal tape) or G type # {Homely, ~ The tape is secured at both ends with deafer tape. At the beginning and end of tape, nothing will be recorded for six to seven seconds. ~ The recording feel Is set automatically, regardless of the position of VOLUME, DBB or incredible Surround, w T prevent accidental recording, break out the tab on the left shoulder of the tape side that you went to protect.
RECORDING €D Synchrony Start Recording 1 Load a blank tape into tape deck 2 and a disc into the dies tay. 2 Crass 6D to select £0 mode . » You can program the tracks in the order you want them 10 be recorded {see Programming Fracks). If not, the tracks are recorded according to the selected dies. 3 Tress RECORD to stet reporting. ~» Tho REC flag starts flashing.
i 2 TIMER =+ _Timer Setting * The system can switch on to CD, TUNER or TAPE Y mode automatically at preset time. Jt can serve assn alarm 1o quake you up. After naif an hour from the preset time, the system will cuter ta the standby mode i no button is pressed. Before setting the timer, make sure the chock is set correctly. “The timer has to be reset or start again for hate subsequent preset time, The velum of the timer will be at the last setting before the system is switched to storyboard mode. . .
n MAINTENANCE Maintenance " Loaning the Cabinet * Sea soft cloth slightly moistened with a mild detergent solution. Do not use @ solution containing alcohol, spirits, ammonia or abrasives. Cleaning Sises » When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out. + Do not use solvents such as benzine, thinner, commercially available cleaners, or anti static spray intended for analog records.
