General Information/Safety Information General Information The type plate is located at the rear of the set. Recording is permissible if copyright or other rights of third parties are not infringed. All unnecessary packaging material has been omitted.
usury Preparations Rear Connection swear] © (::W g @ AM Antenna Connection Connect the supplied lop antenna to the AM AERIAL terminal. Stadium the position of the AM Loop antenna for the best reception. FM Wire Antenna Connection Connect the supplied FM wire antenna to the FM 75 Q terminal. Adjust the position of the FM antenna for the best reception, Outdoor Antenna For better FM stereo reception connect an outdoor FM antenna 1o the FM AERIAL 75 terminal using & 75 €2 coaxial wire.
Ha%n @ e [E—— o[ 10 1) ese 29 28 POWER ON ~ 10 switch the set on or to standby mode. SOURCE to select the following TUNER o switch to Tuner mode. €D : to switch to CD mode. TAPE : o switch to Tape mode. AUX 1 o switch to AUX mode {for textual sources, e.g. TV, Laser Disc or VCR sound]. PRESET A or'¥ to select a radio station in memory. Also use for clock and timer setting. TUNING [odor »» ~ o tune to radio stations <€ dower frequencies. ¥ higher frequencies. Also use for clock and timer setting.
Controls 15 CLOCK 1o set the clock. 16 TIMER SET ~ 1o set the timer. 17 DOMED — to display the various features offered by the system. 18 VOLUME — 1o adjust the volume level. 18 TIMER Alfonso — to switch the timer on or off. 20 DIGITAL SOUND CONTROL {DSC) — to select the desired sound effect : JAZZ, ROCK, POP or CLASSIC. ) HEADPHONES 1o connect headphones (o 3.5mm} jack. 22 HIGH SPEED DUBBING to dub from TAPE DECK 2 to TAPE DECK 1 at high speed.
Operating the System PHILIPS @ o Important : Before you begin operating the system, complete the preparation procedures. The set is in the standby mode when the AC power plug is connected to the wall socket and flashes on the display.
ysyfbiug Tuner ) Tuning to radio stations Press SOURCE to select TUNER. 2 Press BAND to select the desired waveband: {not for all versions). 3 Press TUNING for more than one second. ~ The display will show SERE' until a station with sufficient signal strength is found. « Repeat this procedure until the desired station is reached. « To tune to a weak station, briefly press TUNING e« or PP until the display shows the right frequency and/or when the best reception has been obtained.
Cassette Deck 1) e cots svd w0 e Loading a cassette * Press STOP+OPEN. The cassette compartment door opens. * Load the cassette with the open side downward and the full spool to the left. * Close the cassette compartment door. . Tape Playback 1 Press SOURCE to select either TAPE . 2 Load the cassette into a CASSETTE DECK. 3 Press PLAY » to start playback. 4 Press STOP*OPEN to end playback. Fast Forward/Rewinding 1 You can rewind or fast forward the tape by pressing. <« or P» respectively.
ladybug Cassette Deck Dubbing cassettes {from DECK 2 to DECK 1} 1 Load the per-recorded cassette into TAPE DECK 2 and & bank cassette into TAPE DECK 1. Make sure that both cassettes have their full spools to the left. * For high speed recording, press HIGH SPEED DUBBING. HIGH SPEED DUB BRIG — HIGH SPEED appears on the display. 2 Press PAUSE on TAPE DECK 1. 3 Press RECORD on TAPE DECK 1 ~ RECORD appears on the display. 4 Press PLAY on TAPE DECK 2. Recording will start automatically.
Compact Disc @ o T‘ Warning! 1) This sites designed for conventional C0s. Do not use any accessories like disc stabilizer rings or CD treatment sheets, etc, which may damage the CD mechanism. 2} Do not load more than one dies into the tray. In addition to the conventional 12-cm disc, 8-cm dies can also be used without an adapter. Loading a Disc 1 Press SOURCE to select COI. 2 Press OPENS CLOSE. ~+ The CO tray slides out. 3 Load a disc with printed side up. 4 Press Closeness to close the CD tray.
Compact Duse Shuffle SHUFFLE — playing all the tracks in random order. It can lass be used during program mode. To shuffle all the tracks 1 Press SHUFFLE. "SHUFFLE" appears briefly on the display. — The sure flag and the track selected at random appear on the display. ~ The tracks will now be played in random order until you press STOPPABLE. 2 Press SHUFFLE again to resume normal play. — The furriness flag disappears from display.
Clock Setting Timer Setting FW332 ) misspend e Setting the clock The clock will display in 24-hour mode, e.g. 8:20 or FAERIE, 1 Press CLOCK. ~ "G0:08" stats flashing 2 Set the hour with PRESET Set the minute with TUNING i carpi. 4 Press CLOCK again to store the setting. = The clock starts running. Note: ~ When a power interruption occurs, the clock settings are erased, and "5 00" will flash on the display. Setting the Timer « The system can switch on to TUNER or CD mode automatically at a preset time.
emulsify Maintenance Maintenance Cleaning the Cabinet * Use a soft cloth slightly moistened with a mild detergent solution. Do nat use a solution containing alcohol, spirits, ammonia or abrasives. Cleaning Discs ® ‘When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out, * Do not use solvents such as benzine, thinner, commercially available cleaners, or anti-static spray intended for analog Records.
Troubleshooting Guide Warning! Under ne circumstances shooed you try to repair the set yourself, as this will invalidate the warranty. » ifa fault scours, check the points sifted below before taking the set for repair. * Should any problems persist after you have made these checks, consult your nearest dealer or service center. Symptom Cause Remedy Radio Reception The STEREO indicator flashes, The signet is o weak, Adjust the antenna. Severe hum or aegis ‘The signal strength is too weak, Adjust the antenna.
