PRECAUTIONS / PREPARATION CONNECTIONS Precautions Speakers Connections On Operating Voltage Before operating the system, check that the operating voltage indicated on the type plate [or the voltage indication beside the voltage selector} of your system is identical with the voltage of your local power supply. The type plate is located at the rear of your system, If not, please consult your dealer.
CONNECTIONS CONTROLS ysifbuzg FM Wire Antenna Connection Remote Control Functions Connect the supplied FM wire antenna to the FM 7502 terminal. Adjust the position of the FM antenna for optimum reception. For better FM stern reception connect the outdoor FM antenna to the FM 75 terminal, using 7502 coaxial cable.
CONTROLS ladybug Amplifier and Tuner Cassette Decks and CD 1 POWER ON 22 HIGH SPEED DUBBING — To switch the set on or to standby mode. 23 CASSETTE COMPARTMENT DECK 2 2 SOURCE 24 CONTROLS DECK 2 (RECORD/PLAYBACK) To select the following €D : to switch to CD mods. TUNER : to switch o Radio mode, TAPE : to switch to Tape mode. AUX : to switch to AUX mode (for external sources, e.9. TV sound). 3 DIGITAL SOUND CONTROL (DSC) To select the desired sound effects : ROCK, POP, JAZZ, CLASSIC, or FLAT.
AMPLIFIER DISASTROUS Comoros. wH seed numeral Switching on the system Press POWER ON. Switching off the system (standby mode)} ~ Press POWER ON again {or STANDBY on the remote control). Selecting Sound Secures Press SPURGE w aftereffect CD, TUNER, TAPE or AUX for TUNER or €D on the remote control). — The display indicates the selected sound source. Volume Adjustment Adjust VOLUME f{or press the remote contra) to increase or decrease the sound level .
TUNER 10 m MR mummer WHOLESALER. DEBATER AU Tuning Tuning to Preset Station 1 Press SOURCE to select TUNER, 2 PressBANDtoselectdesiredwaveband. Nonavailability for specific medal. 3 Press TUNING e« or»s: for more than 1 second. ~ The frequency display will change until a station with sufficient strength is found. * Repeat this procedure until the desired station is reached.
CASSETTE DECKS aver 4 racetrack sear slaver 2 TE) e Microphone mixing {for specific versions only} oy < » Astor says recons Press PLAY on DECK 1. Loading a cassette 4 Press RECORD on DECK. — “RECTOR appears on the display. « F Press & STOP (EJECT). . o The cassette door pens, 5 Press A STOP on DECK 2 to stop dubbing. * Load the cassette with the open side downward. Notes: * (lose the cassette door. — At the end of side A, flip the cassette ta side B and repeat procedure.
COMPACT DISC St pa-eause NoT e OrE Notes on handling sides * To keep the disc clean, handle the disc by its edge. Do not touch the surface. * Do not stick paper or tape onto the disc. « Do not expose the disc o direct sunlight or heat sources. * After playing, store the disc in its case. Loading Disc 1 Press SOURCE to select CD. 2 Press OPEN / CLOSE. 3 Loadadisewithprintedsideup. Nontraditional conventional can also be used without an adapter. 4 Press OPEN /LOSE.
COMPACT DISC TIMER-ACTIVATED OPERATION GD Recording Setting the Timer Bering €D recording, * iris not advisable to wind/rewind your cassette in DECK 1. * tight not possible to fasten to other sound source. €D Synchrony-start Recording Crass SOURCE to select CD. Load a disc into the tray. Load a blank cassette (full spool to the left) into DECK 2. Press e« PERV or NEXT wei 10 select the desired track I desired, you can make a program from the disc in the order you want them to be recorded.
MAINTENANCE / SPECIFICATIONS stinkbug | Maintenance Cleaning the Cabinet * Use a soft cloth slightly moistened with mild detergent solution. Do not use solution containing alcohol, spirits, ammonia or abrasive. Cleaning Sises * When a disc becomes dirty, clean it with a cleaning lath. Wipe the disc from the center out. * Do not use solvents such as benzine, thinner, commercially available cleaners, or anti-static spray intended for analog sides.
TROUBLESHOOTING GUIDE The following checks will assist in the correction of most problems wish you may encounter with your system. Before going through the check list below, first check the following points. s The power cord must be connected firmly. vy The speaker connection must also be lire. Should any problem persist after you have made these checks, consult your nearest dealer. Symptom | Cause (and Remedy} Radio Reception The STEREO indicator flashes. {Adjust the antenna) Severe hum or noise.
