INSTALLATION usyiug CONNECTIONS (Fig. 2) A} Terminals for loudspeakers, minimum impedance B ohms. Attach loudspeaker scabies to the unit {see Flg. 2nd 3}, Leftspeaker:connectihe handwritten dotted wire to terminal + L, the brown wire to terminal~ L. Right speaker: procedure. repeat the same 8) Terminal for FM 75 ohm antenna. The antenna wire supplied with the unitize connected o this terminal.
CONTROLS CONTROLS ON THE UNIT {Fig. 4) 1 POWER To switch the unit on and off (standby mode}. 2 STANDBY Yo indicate the unit is in standby mode. 3 REMOTE SENSOR Torecelvesignalsfromtheremote control. 4 DISPLAY To indicate what function the unit is performing. 5 GRAPHIC EQUALIZER (3 BAND) To adjust tone. & BALANCE To set the stereo sound balance between the speakers. 7 POWER LEVEL To indicate the power output level. 8 DIGITAL BUTTONS 1-8 To store and to recall up o 24 preset stations stored in the memory.
CONTROLS OPERATION PAUSE Burton: to temporarily OPERATION é‘ interrupt recurring or payback. E 21 CASSETTE COMPARTMENT DECK 1 Standby Indicator 22 PHONES Connection for headphones {impedance 8-32 ohms). 23 HIGH SPEED DUBBING To dub a cassette at high speed. 24 BASS BOOST o switch the Bass Boast on and off for extra bass. ON THE EMOTE CONTROL {Fig. 4} 1 MUTE Ta witch the sound off. 2 CD CONTROLS — CD: Performs the same functionalist CD Button on the unit.
AMPLIFIER TUNER AMPLIFIER * Press POWERtoswitchtheunitonandat the same time select the required sound source (D, TUNER, TAPE or AUX}, * Adjust the volume with the VOLUME controller unit (or A VOLUME on the remote control. : * Set the tone with the EQUALIZER. For extra amplification of the bass, use the BASS BOOST control. Set the stereo sound balance with BALANCE, * PrassPOWERtoswitchtheunittostandby mode. . .
TUNER ladybug AUTOMATING TUNING Crass AUTO MANUAL. —~The TUNER display shows “Auto Tuning.” X Press UP TUNING/TUNING Downfall second or more, then release the button. ~The tuner will automatically search for the first station of sufficient signal strength, Repeat this procedure if you wish to select another station. . MANUAL TUNING Crass AUTO MANUAL on the unit, —*Auto Tuning" disappears from the display.
COMPACT DISCS COMPACT DISCS (CD) Usecompactdiscsbearingthe symbol below. In addition to the conventional 12 em CDs, 8.0m.C0s can be used without an adapter. DIGITAL AUDIO. Bear in mind the following points, since any dint, scratches or warping of the disc can cause broken or intermittent sound and also noise.
COMPACT DISCS busy 10 inserting the discs * Press CD on the unit or remote control, * Press OPEN/CLOSE on the unit, insert G, printed side up in the left fray, and this wail be DISGUISE. A CD placed in the right tray becomes DISC 2. {See Fig. 8) Press PLAY/PAUSE on the unit or Ml on the remote control. (See Fig. 9) «The tray will rotate 120° clockwise and playback of DISC 1 will begin, (1) #ashes to indicate the playback of DISC 1, and the display shows the current track number and its elapsed playing time.
COMPACT DISCS Note: This is an "AUDIBLE SEARCH". The volume will automatically be reduced to slow level during search operation and will return 1o its normal level when the search button is released. Repeat Play * During play, press REPEAT, The REPEAT 1 indicator lights up. —The current track is played and then repeated. « Press REPEAT again, REPEAT DISC will appear on the display. —All tracks in the disc are played and then repeated. Press REPEAT thee times. —REPEAT ALL DISC will appear on the display.
COMPACT DISCS yspbug 12 « After programming tracks from DISC 2, press DISC again. ~The tray will not rattle, but DISC 3 indicator will begin to flash. » Place the third disc in the right ray and programthedesirediracksusingthesame procedure described above. Reviewing the programmer « Press TIME REVIEW and hold. ~The review of the tracks currently programmed will begin. Playing a program * Press PLAY/PAUSE. ~Play starts with the first track of the program.
CASSETTE DECKS CASSETTE DECKS GENERAL INFORMATION Copyright: Recording is permissible insofar asgupytightarotherrights of third parties are not Infringed. ~ Recording is only possible with DECK 1. The tape In the cassette is secured at both ends with leader tape. At the beginning and end of the cassette, nothing will be recorded for six to seven seconds. For recording, cassettes of IEC type | should be used.
CASSETTE DECKS ysyibug 14 Note: While dubbing a cassette at high speed, you can listen to another secure if you want, necessary to place the unit in TAPE mods. PLAYBACK Playback of one cassette » Press TAPE on the unit (iron the remote control). * Place the cassette tape in DECK t or DECK 2, * Press PLAY ¥ to stair playback.’ -~ Playback stops when the tape reaches the end, * Press Stop alfyouwantiostopplayback before the end of the tape.
MAINTENANCE MAINTENANCE THE SYSTEM * Chamois leather slightly moistened with wailers sufficientforcleaning the housing of the unit and the enclosures. » Do not use cleaning agents containing alcohol, spirits, ammonia or abrasives. THE CD PLAYER * Keep the CD tray free of dust using a clean cloth, Theses * Never write on the printed side into attach any stickers Keep the shiny surface of a CD clean. Use a soft lint-free cloth and always wipe the CD in a straight line from center to edge. (Fig.
