User Guide

WARNING
Under no circumstances should you try to repair the set yourself as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
If a fault occurs, first check the points listed, before taking the set for
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
Laser safety
This unit employs a laser. Only a qualified service person should remove
the cover or attempt to service this device, due to possible eye injury.
Problem Solution
No power, no sound – Adjust the volume.
– Disconnect headphones.
– Make sure speakers are properly connected.
– Connect mains cable properly.
No reaction to controls – Disconnect the set from power supply, reconnect after a few seconds.
Automatic start of permanent – Keep Ç on the set pressed for at least 5 seconds to cancel the
feature display (demo mode) demonstration mode.
Poor radio reception – Direct the antenna for optimum reception.
– Do not position the antenna near a radiation source such as TV,VCR,
computer, etc. Change the position of the interfering set or try to switch it off.
Poor bass sound – Connect the coloured (or marked) wires to the coloured terminals and the
black (or unmarked) wires to the black terminals.
Remote control does not function – Insert new batteries and/or insert batteries correctly.
properly – Select the desired source key before selecting the function key.
– Reduce distance to the set.
Insert Disc indication – Make sure the disc is not scratched or dirty. Replace or clean the disc.
– Make sure disc is inserted, label upwards.
– Wait until steamed up laser lens has cleared.
Wrong Disc indication, – Check if a digital audio disc is inserted, marked with “Digital Audio” and the
Use Audio CD indication special logo.
Check Input indication – Check if the connection cable is properly connected.
Does not record – Make sure the CDR(W) is absolutely free of scratches and dust particles.
– Check if a digital audio CDR(W) is inserted and make sure it is unfinalized.
Stops during recording – Use Philips audio CDR(W)s.
– In case recording process is interrupted (power loss, mechanical shock), start
recording again with a new disc.
Recorded disc does not play in – Make sure the CDR(W) is finalized.
another standard CD player – Insert the CDRW in a CDRW compatible CD player.
Missing directories on MP3-CD – Only albums with playable files will be shown.
Recorded tracks have been merged – Use another track increment mode.
together or tracks do not start/stop – Insert track increments manually with the remote control.
at the correct time
Troubleshooting
27
English