Flat TV
CVBS 1 CVBS 2 Y/C Y DVD/HD1 Cb/Pb Cr/Pr VGA 2 R/Cr/Pr G/Y MAINS INLET RGB/DVD/HD2 B/Cb/Pb HD VD DVI 3 EXTERNAL CONTROL CVBS VGA 1 VGA 2 B/Pb/Cb H VIDEO 1 (AV1) RC-OUT MAINS INLET L L R R AUDIO IN Y CVBS AV1 Y/C S-VHS L CVBS AV3 AUDIO RS232 ~ MAINS Y/C S-VHS VIDEO 2 (AV2) DVI-D G/Y/Y R/Pr/Cr VIDEO 3 (AV3) CVBS L VGA 1 VGA 2 DVI-D ~ MAINS VGA 2 H B/Pb/Cb L L R R VGA 1 AUDIO IN AUDIO IN Y/C S-VHS AV2 AV1 DVI-D AUDIO G/Y/Y R/Pr/Cr AV3 V AUDIO IN AUDIO
Return your Warranty Registration card today to ensure you receive all the benefits you’re entitled to Once your PHILIPS purchase is registered, you’re eligible to receive all the privileges of owning a PHILIPS product. So complete and return the Warranty Registration Card enclosed with your purchase at once, and take advantage of these important benefits.
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions.
Contents Installation English Preparation .....................................................................................................4 Use of the remote control ....................................................................5-6 Buttons in front of the TV receiver box ..................................................6 To use the menus ........................................................................................7 Select the menu language ...........................................
Preparation Do not insert the power plug in a wall socket before all connections are made. ( Remote control: Remove the cover of the battery compartment. Insert the 2 batteries supplied (Type R6AA-1.5V). min. 4 ft The batteries supplied do not contain the heavy metals mercury and cadmium. Nevertheless in many areas exhausted batteries may not be disposed of with your household waste. Please check on how to dispose of batteries according to local regulations.
Use of the remote control v Press this button repeatedly to select AV1, or TV channels when in TV mode, according to where you connected the accessory devices (p. 16). Remark : in VGA mode only some buttons are valid. See VGA menu, p. 20. AV2, AV3, AV4, AV5, FRONT,VGA B CBL VCR DVD SAT AMP l v Ò CBL VCR DVD SAT AMP Press the Select button repeatedly to select one of the system modes in which the remote control can be used.
B CBL VCR DVD SAT AMP l x Pixel Plus demo on/off v Ò ® Select ‡ † π l In the right part Pixel Plus and Digital Natural Motion is switched on. x CC ® ® V Volume To adjust the volume. OK ® ® S ¬ Mute Interrupt the sound or restore it. MENU + + V ¬ CH - - CH Channel selection To browse through the TV channels or sources stored. i Dual screen/PIP on/off See Settings, General menu, Dual screen format, p. 8 and Dual screen, p. 15.
To use the menus & Press the MENU button on the remote control to summon the main menu. At any moment you can exit the menu by pressing the MENU button again. é Use the cursor in the up/down direction to select the TV, Settings or Install B menu. Note: Sometimes not all the menu items are visible on the screen (indicated by a cluster of blue balls). Press the cursor down to reveal all items.
Settings menu TV The General menu allows you to change settings that will typically be accessed only occasionally. The Source menu allows you to select a source. General Source Settings Install General This menu allows you to change various settings that are presumably adjusted less frequently than most other settings.
OSD (On Screen Display) & Select OSD with the cursor down. é Press the cursor right to select Normal or Minimum. Normal to activate extended display of TV channel and channel information on screen. Minimum to activate the display of reduced channel information. Time zone This function allows you to select your local time zone. Broadcasted time information will correct the clock display for your local time. & Select Time zone with the cursor down. é Press the cursor right.
TV menu Press the MENU button on the remote control to summon the main menu. Picture menu Picture Sound Features Channels TV Auto picture Contrast Brightness Color Sharpness Color temperature Digital processing Dynamic contrast DNR Color enhancement Tint Picture format Press the cursor right to select Picture. Select the menu items in the Picture menu with the cursor up/down. Adjust the settings with the cursor left/right or enter the list of submenu items with the cursor right.
(Sound menu) Picture Sound TV Auto sound Volume Treble Bass Balance Headphone volume Sound mode Alt audio (Audio only) Features Channels Note : In case you connect your TV receiver box with a speakerless monitor and without having connected an audio receiver, all references made to sound reproduction, volume control and audio connections are not applicable. Press the cursor right to select Sound. Select the menu items with the cursor up/down and adjust the settings with the cursor left/right.
Features menu The counter runs from 0 up to 180 mins (in 5-min increments).When set to 0, the sleeptimer is turned off. One minute before the sleeptimer expires, a message appears that the TV will turn off in 60 seconds or you may cancel the sleeptimer by pressing the OK button.You can always turn off your TV earlier or change the set time.
TV Ratings Lock Age-based Rating Content-based Rating All None TV-Y TV-Y7 TV-G TV-PG none none none (FV) Fantasy Violence none (D) Dialog (L) Language (S) Sex (V) Violence (D) Dialog (L) Language (S) Sex (V) Violence (L) Language (S) Sex (V) Violence TV-14 TV-MA TV-Y appropriate for children of all ages with themes and elements suitable for children aged 2-6 TV-Y7 programs designed for children age 7 and older TV-Y7-FV programs include fantasy violence more intense than other programs in the TV-Y7 ca
Movie Ratings Lock This function allows you to control access to individual movies based on their MPAA ratings (Motion Picture Association of America). Picture Sound Features Channels TV Channel list Lock after Channel lock TV ratings lock Movie ratings lock Channel remove Settings Install NR G PG not rated movies with a mild content, suitable for all ages movies for which parental guidance is recommended.
Dual screen / PIP / Multipip 7 8 9 i 0 0 Active Control b h 0 q q b Press the b button to switch on Dual screen or one of the PIP modes according to the format selection made in the Dual screen format list in the General menu. See Settings, General, p. 8. Press the b button again.The screen that has a yellow border will become the full main screen picture.
Connect Accessory Devices There is a wide range of audio and video devices that can be connected to your receiver.The following connection diagrams show you how to connect them to the back or the front side of the receiver. Note: In case of the monitor in a stand alone situation without the receiver box connected, see the instructions with the monitor.
Satellite Receiver & Connect the satellite antenna cable 1 to the satellite receiver’s SATELLITE IN jack. AV 1 AV 2 IN IN VIDEO OUT é Connect the Video, Audio left and right (only for stereo devices), AV cables 2 to the VIDEO, L and R AUDIO input AV1 IN, AV2 IN or AV3 IN jacks.
AV5 Digital Set Top Box AV 5 Connect your Set top Box to the AV5 input. AV 3 IN IN VIDEO L AUDIO R H V G/Y B/Pb R/Pr L R Y Pb Pr L R S VIDEO • Connect a Set top Box with 2 Fh RGB output to the H, V, Y, Pb and Pr jacks and to the L and R AUDIO jacks. Connect a Set top Box with 2Fh Pr, Pb,Y output to the Pr, Pb and Y jacks and to the L and R AUDIO jacks. See also the manual of your High Definition Set top Box.
Headphone & Insert the plug into the headphone socket L behind the door at the front side of the receiver. Press the center of the door to open. é Press ¬ on the remote control to switch off the internal loudspeakers of the TV. The headphone impedance must be between 8 and 2000 Ohm. The headphone socket has a 3.5 mm jack. L In the SOUND menu select Headphone volume to adjust the headphone volume. Note: When a TV channel or external source is blocked via the Channel Lock menu (see p.
VGA menu Only available when a VGA source has been connected and activated. See also the separate supplied instruction manual with your monitor. Note : In case you connect your VGA source with a speakerless monitor and without having connected an audio receiver, all references made to sound reproduction are not applicable. & Select VGA with the v button. é Press the MENU button to switch on the VGA menu. Picture 1 Picture 2 Sound Setup VGA “ Select one of the menus with the cursor left/right.
Record with your Recorder To record S-VHS quality, connect an S-VHS peripheral directly to the recorder. Record a TV program You can record a TV program using your recorders tuner without affecting your TV. & Select the channel number on your recorder. é Set your recorder to record. See the handbook for your recorder. Switching channel numbers on your TV does not disturb recording ! Record a recorder from VIDEO OUT You can record a program on your recorder from the TV tuner via VIDEO OUT.
Remote Control Direct Entry Codes for Accessory Devices Amplifier Carver . . . . . . . . . . . . . . . . . . . . . . . . . . .0296 Curtis Mathes . . . . . . . . . . . . . . . . . . . . .0327 GE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0105 JVC . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0358 Linn . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0296 Magnavox . . . . . . . . . . . . . . . . . . . . . . . . .0296 Marantz . . . . . . . . . . . . . . . . . . . . . . . . .
Remote Control Direct Entry Codes for Accessory Devices VCR (continued) Magnin . . . . . . . . . . . . . . . . . . . . . . . . . . .0267 Marantz . . . . . . . . . . . . . . . . . . . . . .0108, 0062 Marta . . . . . . . . . . . . . . . . . . . . . . . . . . . .0064 Matsushita . . . . . . . . . . . . . . . . . . . .0062, 0189 Memorex . . . . . . . . . . .0131, 0074, 0506, 0027 . . . . . . . . . . . . . . . . . . .0064,0075, 0062, 0267 . . . . . . . . . . . . . . . . . . .0066, 0189, 0236, 1189 Minolta . . . .
Before Calling Service Please make these simple checks before calling service.These tips may save you time and money since charges for television installation and adjustments of customer controls are not covered under your warranty. Symptoms Items to Check and Actions to follow “Ghost” or double images • This may be caused by obstruction to the antenna due to high rise buildings or hills. Using a highly directional antenna may improve the picture.
Tips Care of the screen Clean the TV with a slightly damp soft cloth. Do not use abrasive solvent as it can damage the TV screen. minimize the amount of materials that must be disposed. Please ensure that you dispose of your old TV according to local regulations. End of life directives We are paying a lot of attention to using environmentally-friendly production methods.Your new TV contains materials which can be recycled and reused.
FACTORY SERVICE LOCATIONS • San Francisco/Metro Area Milwaukee ★ Detroit/Toledo • Cleveland/N Ohio • • Chicago ★ Columbus ★ Cincinnati ★ Los Angeles Knoxville/E Tennessee Nashville ★ ★ Charlotte • Chattanooga ★ ¥ • Atlanta/N Georgia • Dallas-Fort Worth ★ Indicates In-Home Service Only Milwaukee: call Chicago Cincinnati and Columbus: call Cleveland Nashville and Chattanooga: call Knoxville Washington/Baltimore: call Philadelphia Charlotte: call Atlanta All Florida locations: call Tampa Los Angeles: c
FACTORY SERVICE LOCATIONS Qualiy service is as close as your telephone! Simply look over the list below for the number of a Factory Service Center near you. Your product will receive efficient and expedient carry-in, mail-in, or in-home service, and you will receive peace of mind, knowing youru product is being given the expert attetin of Philips’ Factory Service. Comment obtenir notre service après vente rapide et efficace soit par courrier, à domicile, ou en se présentant à un centre de service Philips.
LIMITED WARRANTY One Year Free Labor One Year Free Service on Parts WHO IS COVERED? MAKE SURE YOU KEEP ... You must have proof of purchase to receive warranty service. A sales receipt or other document showing that you purchased the product is considered proof of purchase. Please keep your sales receipt or other document showing proof of purchase. Attach it to this owner’s manual and keep both nearby. Also keep the original box and packing material in case you need to return your product.
