FC9108 M T Re a c h & C le a n Specialist 13cm
2 9 1 25 7 4 3 10 8 21 20 21 16 11 17 18 19 22 15 5 23 12 14 26 24 13 6
ENGLISH 6 FC9108 15
ENGLISH Important ◗ Only use Philips s-bag` double-layer paper dustbags (type FC8021). ◗ Check if the dustbag has been placed correctly. ◗ Never use the vacuum cleaner to suck up water or any other liquid. Never suck up ashes until they are cold. ◗ When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become clogged, causing the passage of air through the dustbag to become obstructed.
ENGLISH 7 Connecting accessories Hose C 1 To connect the hose, push it firmly into the appliance (you will hear a click). C 2 To disconnect the hose, push the buttons on the swivel and pull the hose out of the appliance. Tube Button coupling C ◗ Connect the tube to the handgrip by pressing the spring-loaded lock button on the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in the tube ("click").
ENGLISH Telescopic tube C 1 Connect the tube to the handgrip ("click"). 2 Adjust the tube to the length you find most comfortable during vacuum cleaning. Reach & Clean nozzle C ◗ The Reach & Clean nozzle can be used on either carpets or hard floors.The nozzle can be put in 4 different positions, allowing you to also vacuum clean hard-to-reach places in an easy way.The nozzle can be turned 360 degrees clockwise as well as anticlockwise.
ENGLISH C 3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean large soft floor areas.Turn the nozzle 90 degrees clockwise again to position the nozzle breadthwise and to make the brush strip disappear into the nozzle housing. C 4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean small soft floor areas.Turn the nozzle 90 degrees clockwise again until it is positioned lengthwise with the brush strip still folded in.
ENGLISH C ◗ Please be aware of the way in which the small nozzle must be placed in the accessory holder. C ◗ Instead of the small nozzle, the small brush can be stored in the accessory holder by pushing it into the holder.To detach it, pull it out of the holder. Vacuum cleaning C 1 Pull the cord out of the appliance and put the mains plug in the wall socket. C 2 Switch the appliance on by pushing the on/off button on top of the appliance with your foot.
ENGLISH Adjusting suction power ◗ You can adjust the suction power while vacuum cleaning. C C 1 Use the slide control on top of the appliance. 2 Set the slide control to MAX for maximum suction power. Use maximum suction power for vacuum cleaning very dirty carpets and hard floors. 3 Set the slide control to MIN for minimal suction power. Use minimum power for vacuum cleaning curtains, table carpets, etc. Storing the vacuum cleaner 1 Switch the appliance off.
ENGLISH C 3 Open the cover. C 4 Lift the dustbag holder out of the appliance. Make sure you hold the dustbag upright when lifting it out of the appliance. C C 5 Remove the full dustbag from the holder by pulling the cardboard tag. When you do this, the dustbag will be automatically sealed. 6 Slide the cardboard tag of the new dustbag into the two grooves of the dustbag holder as far as possible. Re-insert the dustbag holder into the vacuum cleaner.
ENGLISH C 13 3 Press the filter holder with the clean filter firmly into place to ensure that it fits properly at the bottom. 4 Place the dustbag holder with the dustbag back into the appliance. Motor Outlet Filter The AFS Micro Filter at the back of this appliance will filter a large part of the smallest particles from the exhaust air by means of its electrostatically charged fibres. 1 Replace the AFS Micro Filter once a year. C 2 Open the filter grille. C 3 Remove the old filter.
ENGLISH Environment To make recycling possible, the plastics used for this appliance have been coded. The cardboard packaging has been made of recycled material and is fully recyclable. Replacing the mains cord If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required.
™
™
2002/05
