User manual



1 To detach the lter grille, push the tab downwards (Fig. 22).
2 Take out the exhaust lter. Shake out the dirt over a dustbin (Fig. 23).
3 Put back the exhaust lter (Fig. 24).
4 To reattach the lter grille to the vacuum cleaner, align the two ridges of the grille with the
two slots on the vacuum cleaner and close the grille (‘click’) (Fig. 25).

Never use the appliance without the motor protection lter. This damages the motor and
shortens the life of the appliance.
1 Take the motor protection lter out of the appliance.
2 Clean the lter by shaking the dirt out of it over a dustbin.

Replace the dustbag if it can no longer be cleaned properly. Reuseable dustbags are available under
service number 9965 0001 6015.

- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the
environment (Fig. 26).

If you need service or information or if you have a problem, please visit the Philips website at www.
philips.com or contact the Philips Consumer Care Centre in your country (you nd its phone
number in the worldwide guarantee leaet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.

Problem Possible cause Solution
The suction
power is
insufcient
The suction power slide on
the handgrip is open.
Close the suction power slide on the
handgrip.
The electronic suction power
control is set to a low setting.
Set the electronic suction power control to
a higher setting.
The dustbag is full. Empty the reusable dustbag.
The motor protection lter
and/or the exhaust lter is
dirty.
Shake these lters over a dustbin to clean
them.
 9