operation manual

5 Cleantheinnerlterandtheouterlterwithabrushorwithastandardvacuumcleanerif
they are very dirty.
Note: If necessary you can clean the inner lter and the outer lter in cold or lukewarm water. Dry the
inner and outer lter thoroughly before you use the lter unit again.
6 Placetheinnerlterbackontothelterholder(1)andturnitanticlockwisetoattachit
(2). (Fig. 24)
7 Placetheouterlterbackontothelterholder(1)andturnitanticlockwisetoattachit
(2). (Fig. 25)
8 Putthelterunitbackintothedustcompartment(Fig.26).
Note: Make sure you insert the lter unit in the correct way. The word ‘up’ must point towards the top of
the dust compartment.
9 To reattach the dust compartment, align the slot on the dust compartment with the
projection on the handheld vacuum cleaner. First attach the bottom of the dust compartment
(1) and then push the top of the dust compartment towards the vacuum cleaner (2) until it
locks into place (‘click’). (Fig. 20)
Cleaning the oor nozzle joint
The joint of the oor nozzle may get blocked by large dirt particles. Follow the steps below to clean
the joint.
1 Press the on/off button on the stick to switch off the appliance.
2 Press the handheld vacuum cleaner release button (1) and remove the handheld vacuum
cleaner from the stick (2) (Fig. 11).
3 Presstheoornozzlereleasebutton(1)todetachthestickfromtheoornozzle
(2) (Fig. 27).
4 Remove the large dirt particles from the joint.
5 Placethestickbackontotheoornozzle(‘click’).
Cleaning the roller brush
When the ‘brush blocked’ light starts to ash red, the roller brush is blocked. If this happens, follow
the steps below to clean the roller brush.
1 Press the on/off button on the stick to switch off the appliance.
2 Press the handheld vacuum cleaner release button (1) and remove the handheld vacuum
cleaner from the stick (2) (Fig. 11).
3 Presstheoornozzlereleasebutton(1)todetachthestickfromtheoornozzle(2).
4 Turntheoornozzleupsidedown.
5 Move the roller brush until the cutting groove faces you. (Fig. 28)
6 Use a pair of scissors to cut the hairs, threads etc. that have collected around the roller
brush. (Fig. 29)
7 Removeuff,hairsandotherdirtfromtherollerbrush.
Note: You can also remove the roller brush for easier cleaning.
ENGLISH 11