User manual

Preparing for use
Installing the charger
1 Attachthechargertothewallasshowninthegure.(Fig.2)
Ifyouattachthechargertothewall,thespacebetweenthescrewholes
has to be 12cm.
2 Youcanalsoplacethechargeronahorizontalsurface(e.g.atable
ordesk)(Fig.3).
3 Windexcessmainscordaroundthereelinthebackofthecharger
andpassthecordthroughtheslot(Fig.4).
Charging the appliance
Chargetheapplianceforatleast16hoursbeforeyouuseitfortherst
time.
1 Makesuretheapplianceisswitchedoff.
2 Puttheadapterinthewallsocket.
3 Placethevacuumcleaneronthecharger(Fig.5).
Makesureyouplacetheopeninginthebackofthevacuumcleaner
on the hook of the charger (Fig. 6).
Thecharginglightgoesontoindicatethattheappliance
ischarging(Fig.7).
Note: The charging light stays on as long as the appliance is in the plugged-in
charger.
Note: The charging light does not give any information about the battery
charge level of the vacuum cleaner.
Using the appliance
1
Pushtheon/offslideforwardstoswitchontheappliance(Fig.8).
2 Pushtheon/offslidebackwardstoswitchofftheappliance(Fig.9).
-
,
ENGLISH8