Instructions for use

Note:To clean the inner lter, you can remove the outer lter from the lter
holder by turning it anticlockwise.
Note:You can clean the outer lter and the inner lter with a brush or with a
normal vacuum cleaner if they are very dirty.
Note:If necessary, you can clean the outer lter and the inner lter in cold or
lukewarm water.
5 Place the outer lter back onto the lter holder and put the lter
holder back into the dust compartment. Make sure you insert the
lter holder in the correct way. (Fig. 12)
Never use the vacuum cleaner if the lter unit is still wet.
Storage
1
You can store the brush tool and the crevice tool by placing them
on the charging unit. (Fig. 13)
Replacement
Replace the inner lter if it can no longer be cleaned properly
(usually after having been cleaned about 50 times).
1 Remove the lter unit from the dust compartment. (Fig. 11)
2 Remove the outer lter from the holder by turning it anticlockwise.
(Fig. 14)
3 Remove the inner lter from the holder by gently turning it
anticlockwise. (Fig. 15)
4 Attach a new inner lter to the holder. (Fig. 16)
5 Push the tip of the inner lter inwards. (Fig. 17)
6 Reattach the outer lter to the holder. (Fig. 18)
,
ENGLISH 9
4222.003.3316.2.indd 9 21-04-2006 16:00:12