Important notes for users in the UK. Italian Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, PASTA. or BS! approved type. 3 Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. I the mains plug contains a fuse, this should have a value of & Amp.
stinkbug INSTALLATION Setting up i you want to set up your amplifier on a shelf, in a cabinet or any other type of enclosure, always ensure that sufficient ventilation is available. An open space of at least 3 cm at the sides and the top, and § em at the back of the stack is required. » Place the power supply cable as far as possible from the sound signal fines in larder to avoid disturbing signal interference.
Front of the amplifier 1 SPURGE SELECTION: AUX.. ..This switch is used to defect the AUX {auxiliary} input. This switch is used for selecting the €D {Compact Disc} input. This switch is used to select the FOND input. This switch is used to select the TUNER {radio} input. .. This switch is used to select the TAPE 1 {cassette deck} input. This switch s used to select the TAPE 2 {cassette deck) input. 2 PHONES... socket is for connecting standard stereo headphones with a 6.3 mm jack.
ysijfiug OPERATION Switching on and off When you want tu switch your amplifier on, press the POWER mutton. The LED in the middle of the button indicates that the unit ion. button depressed: POWER ON button not depressed: POWER OFF ~»The unit will be activated and the source TUNER will be selected. the amplifier is switched to active mode {as described Below], the respective indicators and the LED in the power knob light up.
Protection circuits Your amplifier is provided with series of electrical protection devices which reliably safeguard your speakers against damage. Overloads ara thus almost instantly checked. If your unit overheats, a thermal error is recognized. In this case, the LED in the VOLUME controller quickly blinks, the volume level is automatically traduced and the speakers are disconnected.
ysjfiug TROUBLE SHOOTING Trouble shooting The following checklist will help you to correct most of the problems that can scour with your unit. If the following List does not help, please consult your Whiff dealer. Before you go through the following fist, verify the following points: e The mains cable must be securely connected. =+ The speaker connections must also be secure. Problem The amplifier switches off. Cause {and correction) The transformer could be overheated.
