Important notes for users in the UK. italic Mains plug This apparatus s fitted with an approved 13 Amp plug, To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 fix new fuse which should be a BS1362 5 Amp, AS.TA, or BSI approved type. 3 Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contain a fuse, this should have a value of 5 Amp.
Model XLR520PMD Owner's Manual PROFESSIONAL L~ ] XLR Rear Panel Kit Thank you for purchasing the XLRS20PMD. This product is a kit for use in adding XLR type balanced Outputting to the PMD520. The basic operating procedures of the FMD520 remain the same even after this product has been installed. For details, please refer to the owner's manual of the PMDS20.
fistfight INSTALLATION Setting up ¥ you want to set up your amplifier on a shelf, in a cabinet or any other type of enclosure, always ensure that sufficient ventilation is available. An open space of at least 3 cm at the sides and the top, and 5 em at the back of the stack is required. » Plate the power supply cable as far as possible from the sound signal lines in order to avoid disturbing signal interference.
OPERATING ELEMENTS Front of the amplifier 1 SOURCE SELECTION AUX, his switch is used to select the AUX auxiliary} input. ..This switch is used for selecting the CD {Compact Duse} input. his switch is used to select the PHONON nut. ...This switch is used to select the TUNER {radio) input. .. This switch is used to select the TAPE 1 {cassette deck) input. ...This switch is used to select the TAPE 2 {cassette deck) input. PHONON. 2 PHONES.. ...This socket is for connecting standard stern headphones with a 8.
fuzzy OPERATION Switching on and off » When you want to switch your amplifier on, press the POWER button. The LED in the middies of the button indicates that the unit is on. button depressed: POWER ON button not depressed: POWER OFF ~»The unit will be activated and the source TUNER will ke selected. When the amplifier is switched to active mode {as described below}, the respective indicators and the LED in the power knob light up.
Protection circuits Your amplifier is provided with sexes of electrical protection devices which reliably safeguard your speakers against damage. Overloads ara thus almost instantly checked. If your unit overheats, a thermal error is recognized. In this case, the LED in the VOLUME controller quickly blinks, the volume level is automatically reduced and the speakers are disconnected.
busybody TROUBLE SHOOTING Trouble shooting The following checklist will help you ta correct most of the problems that can scour with your unit. I the following list does not help, please consult your Whiff dealer. Before you go through the following list, verify the following points: «= The mains cable must be securely connected. == The speaker connections must also be secure. Philemon Cause (and correction} The amplifier switches off. The transformer could be overheated.
