Brawn rive must be cannonade 1o the terminal wive is marked with the lefter L or colored Red. g over st be consented ta the terminal chichis marked wth the Teller N or colored Black, te: This apparatus must be protected by 3 3 Amp Luge f & 13 Ambassadorship, anywhere types of Misused, bay's Amn Fuse edgier in the plug or adapter or at the distribution board. i m doubt consult & qualified electrician. CONTROLS Fig.2 {5 ON/OFF switch, for switching the entire unit on/off.
the frequency shown on the display has been programmed. 'FO’ means that the relevant frequency has not been programmed in the memory. « The indication MEMORY' vi hen programming. Tuner reception » Select tuner mode (ratio) with TUNER bunion @. « Select the desired wave band using selector 6. Tune to the desired transmitter: » Press button for more then 0.5 secants. Then release this button. The frequency on the display now changes continuously until a transmitter of sufficient strength has been found.
Copyright Recording is permissible insofar as copyright or other rights of third parties @re not infringed. For U.K. oily: Recording and Playback of mates! sy require consent See Copyright Act 1956 and The Performer's Protraction fold 1958 to 1972, Prepare the recorder for recording as follows: + Open the cassette compartment of deck A by press. ing in "STOPPAGE € once, if necessary evict. * Place the casein the compartment of deck A, vita the open side downwards and the full stoop on the Left {see Fig.
then no longer record on this side. This protection can be removed with @ small piece of adhesive tape, » Store your cassettes afire use in the box provided. Keep the cassettes at room temperature, do not put he min the senor too close magnetometer transformers of 8.9, recorders, radios, TVs and loudspeaker boxes. Connecting loudspeakers Loudspeakers are connected 1o the terminals © (see Fig. and preferable to setup the loudspeakers in'front of the listener. Connect the loudspeakers as follows: .
