Specifications

Directions for use
GB 8 EM1A3.
16
Connect Peripheral Equipment
75
CABLE
VCR
AV 2
in
AV 1
in
Monitor
out
COMPONENT VIDEO INPUT
VIDEO
L/Mono
R
Y
Pb
Pr
AUDIO
S-VIDEO
OUT
OUT
OUT IN
j x
4
1
3
Video recorder and other A/V peripherals
&
Interconnect your video recorder with extra RF cables 3.
é
To obtain better picture quality, also connect the Video,Audio left and Audio right (only for stereo equipment) cables to the
VIDEO
,
AUDIO L/
Mono and
AUDIO R
input of
AV2 IN
sockets 4.
Note: in case of mono equipment, only the left loudspeaker reproduces sound.
Use a mono to stereo adaptor (not supplied) for sound reproduction via all internal loudspeakers. When a video recorder is not connected to
MONITOR OUT
you can only record a
programme from the aerial or from the cable system. Only when a video recorder is connected to
MONITOR OUT
it is possible to record a
programme from other equipment connected to the TV. See Record with your video recorder, p. 18.
15
Connect Peripheral Equipment
Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV.The following connection diagrams show you how to connect them.
&
Connect the RF cable 1 to the RF socket x of your video recorder.
é
Connect another RF cable 2 from the output j of your video recorder to the input x of your TV. Better playback quality can be obtained if you also connect the Video,Audio Left and Right (only for stereo equipment) cables 3 to the
VIDEO
,
AUDIO L/
Mono and
R
input
AV2 IN
.
Note: in case of mono equipment, only the left loudspeaker reproduces sound.
Use a mono to stereo adaptor (not supplied) for sound reproduction via all internal loudspeakers.
The
MONITOR OUT
connectors can be used for daisy chaining or to record
programmes from your TV. See Record with your video recorder, p. 18.
S-VHS-Video
quality with a S-VHS video recorder is obtained by connecting
the
S-VHS-Video
cable with the
S-VIDEO
input instead of connecting the video
recorder to the
VIDEO
input. (See the instructions of your video recorder.)
If the cables 3 are not used the following steps are required: Search for and store the test signal of the video recorder
&
Unplug the RF cable 1 from the RF socket x of your video recorder.
é
Switch on your TV and put the video recorder on the test signal or play a prerecorded tape (See the handbook for your video recorder.).
“
Search for the test signal of your video recorder in the same way as you searched for and stored the TV signals. See Installation, Store TV Channels, Manual Tuning, p. 5.
‘
Store the test signal under programme number 0 or between 90 and 99.
(
Replace the RF cable in the RF socket x of your video recorder after you have stored the test signal.
Video recorder
CABLE
VCR
75
OUT
j x
AV 2
in
AV 1
in
Monitor
out
COMPONENT VIDEO INPUT
VIDEO
L/Mono
R
Y
Pb
Pr
AUDIO
S-VIDEO
3