Specifications

Mechanical instructions
GB 14 EM1A4.
4.2.8 Accessing the Side I/O panel
Figure 4-10
1. The complete Side I/O-assembly can easily be removed
by unscrewing the 2 fixation screws.
2. The board can easily be lifted out of the bracket after
releasing the 2 fixation clamps.
4.2.9 Accessing the Mains Switch panel
Figure 4-11
The easiest way to access this module is with the LSP in
service position 2.
1. Release the two fixation clamps by pulling them
backward [1].
2. At the same time, the complete assy must be pulled
backward [2].
3. If the board has to be removed, release the 2 clamps at
the bracket sides and lift panel up [3].
4.3 Mounting the Rear Cover
Before mounting the Rear Cover, some checks has to be
performed:
• Check whether the Mains Cord is mounted correctly in
the guiding brackets.
• Check whether all cables are replaced in their original
position. This is very important due to the large 'hot' area
of the set.
CL 06532012_004.eps
030200
2
3
1
1
3
CL 06532130_018.eps
021000