Specifications

2.Warnings, lasersafety instructions and notes EN 5

DVP320

Mounting

1. Ensure the cables between a new Loader KHM-280AHA and Mpeg board connect well.

2. Unsolder the ESD protect point on the new Loader KHM-280AHA use a soldering iron with ESD protect carefully.

3. Mantling the Loader.

8 pins cable

Photo 1: Position of ESD protect-point (Bottom view) Photo 2: 8Pins cable is easily hurt

.3.2.3. Mpeg board and Front Display

Generally the Mpeg board and front display are non-repairable units and in case of failure, they have to be replaced with a completely

too. However if necessary they can be repaired down to simple component level. These simple components include power circuit,

quartz circuit, servo driver, Flash, switches, LEDs, cables etc.

.3.2.4. Important Notes

1. Be aware that Item 8002 (8 pins cable 314101021911) is easily hurt by a screw during assembling the cabinets. Refer to wiring

diagram and the above photo 2.

2. The procedures to remove the top mpeg shield.

Ste

1: unlock the two locks in the side near PSU Step 2: Remove the locking tap

Step 3: Remove the locking tap near left side Step 4: Remove the top shield

.3.3. Change of Software setting

The software setting can be change according to the following procedure:

1. Press < OPEN/CLOSE> switch lock on the door to open the door.

2. Enter the 4-digit code <9> <9> <9> <9> on the remote control.

3. Enter one of the keys below to change the software setting.