Specifications
3.Directions for use EN 19
DVP320
25
PLAYBACK SYSTEM
DVD Video
Video CD & SVCD
CD
PICTURE CD
MP3-CD
CD-R, CD-RW
DVD+R, DVD+RW
VIDEO PERFORMANCE
* CVBS 1Vpp --- 75
*Component video Y: 1.00Vpp --- 75
Pr: 0.7Vpp --- 75
Pb: 0.7Vpp --- 75
AUDIO FORMAT
Digital Mpeg/ AC-3/ DTS compressed Digital
PCM 16, 20, 24 bits
fs, 44.1, 48, 96 kHz
MP3(ISO 9660) 24, 32, 56, 64, 96, 128,
256 kbps & variable
bit rate fs, 16, 22.05,
24, 32, 44.1, 48 kHz
Analog Sound Stereo
AUDIO PERFORMANCE
DA Converter 24bit
Signal-Noise (1KHz) 100dB
Dynamic range(1KHz) >90dB
DVD fs 96 kHz 4Hz- 44kHz
fs 48 kHz 4Hz- 22kHz
SVCD fs 48 kHz 4Hz- 22kHz
fs 44.1kHz 4Hz- 20kHz
CD/VCD fs 44.1kHz 4Hz- 20kHz
TV STANDARD (PAL/50Hz) (NTSC/60Hz)
Number of lines 625 525
Playback Multistandard (PAL/NTSC)
CONNECTIONS
Component Video Output Cinch
Video Output Cinch
Audio Output(L+R) Cinch
Digital Output 1 coaxial
IEC958 for CDDA / LPCM
IEC1937 for MPEG1, MPEG 2, Dolby
Digital and DTS
CABINET
Dimensions (w x d x h) 216 x 216x 45 mm
Weight Approximately 0.8 Kg
POWER CONSUMPTION
Power consumption < 8 W
Power consumption in Standby mode < 1.2W
Specifications
Cleaning the Disc Compartment
Always close the CD door to keep the CD
compartment dust-free. To clean, dust the
compartment with a soft dry cloth. Do not use a
solution containing alcohol, spirits, ammonia or
abrasives.
Cleaning Discs
When a disc becomes dirty, clean it with a
cleaning cloth. Wipe the disc from the center out.
Do not wipe in a circular motion.
Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic spray
intended for analog records.
Maintenance
Specifications subject to change without prior notice
Cleaning the disc lens
After prolonged use, dirt or dust may accumulate
at the disc lens. To ensure good playback quality,
clean the disc lens with Philips CD Lens Cleaner
or any commercially available cleaner. Follow the
instructions supplied with cleaner.
26
Troubleshooting
WAR N I NG
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are
unable to remedy a problem by following these hints, consult your dealer or service center.
Problem Solution
No power ñ Check if the AC power cord is properly connected.
No picture ñ Check if the TV is switched on.
ñ Check the video connection.
ñ Set your TV to the correct Video In channel.
ñ If you have activated Progressive Scan function,
make sure that your TV set also has Progressive
Scan and the Y/Pb/Pr cables are correctly
connected.
Distorted picture ñ The disc is badly scratched or dirty.
ñ Sometimes a small amount of picture distortion
may appear .This is normal.
Completely distorted picture or ñ Make sure the NTSC/PAL setting at the DVD
black/white picture with DVD player matches the video signal of your television.
or Vid eo CD (See NTSC/PAL CONVERSION)
ñ If the picture becomes distorted after switching
among PAL and NTSC, please set the SMART
PICTURE to STANDARD.
No sound or distorted sound ñ Adjust the volume.
ñ Check that the speakers are connected correctly.
ñ If the Disc sounds abnormal, set SOUND MODE or
3D SOUND appropriately.
No audio at digital output ñ Check the digital connections.
ñ Check if your receiver can decode MPEG-2 or DTS
and if not, please make sure the digital output is set
to PCM.
ñ Check if the audio format of the selected audio
language matches your receiver capabilities.
ñ Do not connect any cables from the Player to a
Stereoís ìPHONO INî jack.
ñ Deactivate mute at the DVD Player by pressing
MUTE on the Playerís remote.
Disc canít be played ñ The DVD+R/DVD+RW/CD-R must be finalized.
ñ Ensure the disc label is facing up.
ñ Check the Parental controls.
ñ Check the Region Code of the DVD. The DVD
must be coded for All regions or Region 3 in order
to play on this DVD Player.
ñ Check if the disc is defective by trying another disc.
_ If you record a Picture CD or MP3 CD yourself,
ensure that your disc contains at least 10 pictures or
5 MP3 tracks.
No return to start-up screen after ñ Reset the unit by switching the player off, then on
you rem ove a Disc. again.
The player does not respond to ñ Aim the remote control directly at the sensor on
the remote control the front of the player.
ñ Reduce the distance to the player.
ñ Replace the lithium batteries in the remote control.