Quick installation guide

1
Installation with external receiver
Connecting your DVD recorder to the TV
set/Initial installation
Warning ! As long as the initial installation has not been carried out, the buttons on
the front of the DVD recorder remain without function.
1 Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder
2 Insert one end of the supplied aerial cable into the TV OUT socket at
the back of the DVD recorder and the other end into the aerial input
socket of the TV set.
3 Connect the scart socket of the receiver (satellite receiver) provided
for the TV set (usually labelled 'TV', 'TO TV'), with the EXT 2
AUX-I/O socket of the DVD recorder.
4 Connect the G-LINK cable to the G-LINK socket at the back of the
DVD recorder.
5 Position the G-LINK transmitter in front of the external receiver so
that the control signal (IR signal) can be transmitted and received by
the receiver unhindered.
6 Connect socket EXT 1 TO TV-I/O or sockets OUT S-VIDEO
(Y/C) , VIDEO (CVBS) OUT , OUT AUDIO L/R with the
corresponding input sockets of your TV set.
My TV sets supports the functions Easy Link, Cinema Link,
NexTView Link, Qlink, Smart Link, Megalogic, Datalogic,...
Connect the scart socket EXT 1 TO TV-I/O at the back of the DVD
recorder with the - suitable for data transfer - scart socket of your TV set
(see the instruction manual of your TV set) using a special cable (suitable for
these data transfers).
?
7 Switch on the TV set.
8 Use the supplied mains cable to connect the mains socket
4MAINS at the back of the DVD recorder with the wall outlet.
The most important features of the DVD recorder will appear in
scrolling text on the display. After the first installation is completed
this function will be switched off.
IS TV ON?
9 Switch on the DVD recorder using STANDBY-ON m .
'IS TV ON?' will appear on the display.
0 If necessary, select the programme number for the input socket at the
TV set.
ENGLISH