User Guide

English
17
Step 1: Basic Recorder Connections (continued)
Option 4: Using Component
video socket / Connecting to a
Progressive Scan TV
If your TV accepts progressive scan
signals, connect the recorder to your TV
using the component video sockets in
order to enjoy the progressive scan
feature.

Connect the component video cables
(red/ blue/green - not supplied) from the
Y P
B PR sockets on the recorder to the
corresponding component video input
sockets (usually labelled as Y Pb/Cb Pr/Cr
or YUV) on the TV.
Note:
To enable Y Pb Pr (YUV) connection, you
must set the recorder’s video output
correctly. To access the recorder’s
settings for the  rst time, basic video
connection (Scart, S-Video or CVBS) is
required.
A Connect this recorder to your TV using
Scart, S-Video or Video (CVBS)
connection.
B Complete chapters “Step 2: Optional
Connections” and “Step 3: Installation
and Set-up” in this user manual, then
change the video output setting as
follows:
1) Press HOME.
2) Select { Settings } > { Video
output } > { Active video output }
> { Comp. video (YUV) } and press
OK to con rm.

To activate Progressive Scan output, read
chapter “Other information - Setting up
Progressive Scan feature” for details.
C Switch your TV to the correct viewing
channel for this connection.
Option 4
AUDIO OUTVIDEO OUT
R
L
TO TV
EXT1
TO VCR/SAT
EXT2
3139 241 25451
VIDEO
(CVBS)
S-VIDEO
(Y/C)
Y
P
B
PR
COMPONENT
VIDEO OUT
COAXIAL
(DIGITAL OUT)
MAINS
S-VIDEO IN
TV
Option 4
dvdr5500-05n31_eng_25722.indd 17dvdr5500-05n31_eng_25722.indd 17 2007-05-30 10:03:47 AM2007-05-30 10:03:47 AM