Software Upgrade

ManualsBrandsPhilips ManualsVideoDVDR3455H-37B

Philips AVS

DVDR3455/37 Firmware Upgrade

Firmware Upgrade

We have developed a firmware upgrade to improve your product.

This upgrade is applicable for the following models:

DVDR3455/37

This firmware version improves:

Click here for more details

Note: Before you proceed to upgrade, please be reminded that you need to do configuration again

each time after firmware upgrade!

Upgrade Procedure

Ste

Check your current version

First check your current firmware version to see if you need to upgrade:

1. Press <SETUP> to bring up the setup menu, then press <3>, <2>, <1>, <SELECT>

2. The software version is “PS3455H_31_R19.XX” displayed on the TV screen.

3. Compare the version shown on the screen with this firmware upgrade versions, PS3455H_37_R19.10.

If the current software is lower than R19.10, proceed to step 2.

Otherwise, no upgrade is necessary.

Ste

Download Firmware upgrade

Click the link to save the software on your computer.

Ste

Burning Upgrade on CD-R / CD-RW

1. Extract the files by unzipping the zipped file with WINZIP or an other application capable of handling zipped

files (Do not rename the extracted files)

2. Write the extracted files – not the zip file – onto a blank CD-R or CD-RW disc,

using the following settings:

Tip: For more

information on burning

software we refer to

two popular burning

software programs

www.nero.com

www.easycdcreator.com

- File System: ISO 9660 + Joliet

- File name length : max11 chars = 8+3 (Level 1)

- Mode : 2/XA

- Character set : ISO 9660 (ISO normal CD-ROM)

- No multi session

- Write Speed : Low

3. Finalize the disc. (The application may do this automatically.)

Ste

Apply Upgrade to your Recorder

1. Power up the recorder and open the DVD tray.

2. Insert the prepared upgrade CD-ROM.

3. Close the tray and the recorder will auto read the disc.

4. Upon recognize the disc, the local display of recorder will show "FLASH 1". The TV screen will show a

dialog box titled “Disc Upgrade”

5. Note: The recorder will indicate “Unknown Disc” in the following 2 situations.

- When the software upgrade is not meant for your recorder (

Check the applicable models above)

- Problem with writing of CD-ROM. Try again with a different CD-ROM if possible.

6. To proceed with the Upgrade, press <OK> on the remote control. You can cancel the upgrade at this point

by navigating to CANCEL button on TV and pressing <OK> on the remote control.

7. If you proceed with the upgrade, the upgrading status will be shown on the TV screen.

Summary of content (2 pages)

PAGE 1
Philips AVS DVDR3455/37 Firmware Upgrade Firmware Upgrade We have developed a firmware upgrade to improve your product. This upgrade is applicable for the following models: DVDR3455/37 This firmware version improves: Click here for more details Note: Before you proceed to upgrade, please be reminded that you need to do configuration again each time after firmware upgrade! Upgrade Procedure Step 1 Check your current version First check your current firmware version to see if you need to upgrade: 1.
PAGE 2
Philips AVS The whole process takes about 1 minute after which the local display of recorder shows “DONE” and the dialog box on TV screen indicates successful upgrading. The tray will be ejected. 9. Remove the CD-ROM before pressing on the remote control. The recorder should close the tray and restart automatically after about 10 seconds. 10. Note: Do not press any buttons or interrupt the mains supply during the entire upgrading process, otherwise the recorder may become defective.. 11.