Specifications

press SETUP, IN the Front Panel :, press NEXT, press STOP, press PAUSE/STEP
, press PREV, press NEXT.
Mustek DVD-V560
Make sure no disc is in tray, push – SETUP, NEXT, STOP, PAUSE/STEP, PREV,
NEXT. Press RIGHT ARROW until you see "ver 255" (255 = Multiregion)
Disable macrovision, press "SETUP", "NEXT", "PREV", "NEXT", "PREV" .
Press "arrow up", "arrow left" you should see 4000, "arrow up", "arrow left" until
you see 3000 finally press "SETUP"
Mustek DVD-V562
Same as above
Mustek DVD-V56S
Same as above
Mustek DVD-V600 RZ
With the players DVD draw is open push on the remote press the following
numbers: '8,4,2,1', This should bring up a special menu. Press ENTER to toggle
through the region codes and select '9' to enable region bypass.
NAD T-531
Power on the player with no disk in the drive, Press "PAUSE" on the remote, Enter
"3 1 4 1 5 9" on the remote (the word COdE appears on the display), Enter "0" on
the remote (0 = All Regions, 1 = Region 1, 2 = Region 2, etc.), Press "PAUSE" on
the remote, Power the player off and then back on.
NAD T-550
Make sure tray is open. Go to [set up] menu. Go to 'password' press [enter].
Input "5978", Press [enter]; a block with "SVC Code" will appear. Input "92"
[Audio] [Resume]" (yes, this means two digits and two special keys as the
mode). Press [Enter] The block will now show "Region Change 0000". Select
region by input: "550* " where * = region code. E.g. USA = 5501; Europe =
5502. Press [Enter]. The player will close the drawer and switch itself to standby.
Naiko N2051
With remote:- open draw, press set-up, stop, back skip, fwd skip. Now in hidden
menu turn macro off and change region to 0.
Nakamichi DVD-10S