Specifications

2. If the archive does not contain a file named U1100A6X.ROM then you have the wrong one.

3. Create a CD-R using the above file named U1100A6X.ROM. Use the following specifications:

a. ISO9660

b. Mode 1

c. Track at once

d. Close the CD

4. Power on the player without a disk in the drive.

5. Insert the upgrade disk you just created Picture

6. The display will switch to the first upgrade screen if the disk is correct Picture

7. The system will erase the firmware chip Picture

8. The system will then start reprogramming the firmware chip (takes about 40 seconds so be patient)

Picture

9. When the reprogramming is done the display will change Picture

10. After a short delay (less than 5 seconds) the screen will turn blue Picture

11. The drive will eject the disk (screen will go blank)Picture (Remove the disk)

12. The player will power off (screen is still blank)Picture

13. Using the front panel power button (NOT THE REMOTE!), power the unit off

14. After a short delay (3-4 seconds) power the front panel power switch back on Picture

15. Upgrade Complete!

Apex AD-1200

Open tray and press 8 4 2 1 (you will see -'s appear top left of screen) Menu appears for region

and Macrovision, Use up/down keys to select Region/Macrovision. Use Enter to change region

to 9/Macrovision on/off.

Apex AD-1500

Use the same instructions as AD-1000 but use the 1500 rom.

Apex AD-3201

Open the DVD Tray, enter 8421 on the remote. Screen should show the Region and

Macrovision Menu and enter region (9 is Region Free). Select Macrovision On/Off and Close

Tray to save.

Apex AD-500, Apex AD-500a, Apex AD-500b, Apex AD-500w