Specifications

Switch it on
Press Setup, Slow
Press Skip left, Press Skip right
Use the Right Arrow button to select the desired region:
A Region 1, B Region 2, C Region 3, D Region 4
E Region 5, F Region 6, *** Region Free
Press Setup
Mustek DVD V520
With the draw empty, Press setup, then previous, next, previous, next, previous, press right
cursor until 255 appears and finally push set-up.
Mustek DVD-V300
Make sure you don’t have any DVD inserted and Door Closed, IN remote control:,
press SETUP, IN the Front Panel :, press NEXT, press STOP, press PAUSE/STEP , press PREV,
press NEXT.
Mustek DVD-V560
Make sure no disc is in tray, push – SETUP, NEXT, STOP, PAUSE/STEP, PREV, NEXT. Press
RIGHT ARROW until you see "ver 255" (255 = Multiregion)
Disable macrovision, press "SETUP", "NEXT", "PREV", "NEXT", "PREV" . Press "arrow up",
"arrow left" you should see 4000, "arrow up", "arrow left" until you see 3000 finally press
"SETUP"
Mustek DVD-V562
Same as above
Mustek DVD-V56S
Same as above
Mustek DVD-V600 RZ
With the players DVD draw is open push on the remote press the following numbers: '8,4,2,1',
This should bring up a special menu. Press ENTER to toggle through the region codes and
select '9' to enable region bypass.
NAD T-531
Power on the player with no disk in the drive, Press "PAUSE" on the remote, Enter "3 1 4 1 5
9" on the remote (the word COdE appears on the display), Enter "0" on the remote (0 = All
Regions, 1 = Region 1, 2 = Region 2, etc.), Press "PAUSE" on the remote, Power the player off
and then back on.
NAD T-550
Make sure tray is open. Go to [set up] menu. Go to 'password' press [enter]. Input "5978",
Press [enter]; a block with "SVC Code" will appear. Input "92" [Audio] [Resume]" (yes, this
means two digits and two special keys as the mode). Press [Enter] The block will now show
"Region Change 0000". Select region by input: "550* " where * = region code. E.g. USA =
5501; Europe = 5502. Press [Enter]. The player will close the drawer and switch itself to
standby.
Naiko N2051