Specifications

26
If the methods above do not work, you can try this:
Open the player's tray.
Using the remote control, Press 3, 3, 0, 8, 8, 0, in order, and one at a time.
Close the tray.
Open the tray and put the region 1 disc in.
Close the tray - the film should start.
RCE disks may halt the player. For these disks substitute the last 0 in step 2 for the region number of your choice.
Bush 2004A
Open tray type in 33088
Then press 0 for region free
Close tray to complete.
Bush DVD-2005
Power on your player, then from the remote control key in the combination below:
Press Open / Close
Press Zoom
Press A / B
Press Up, Left, Down, Right
The DVD player may show a Region Free message.
Bush DVD-2009
Power on your player, then from the remote control key in the combination below:
Press Open / Close
Press Zoom
Press A / B
Press Up, Left, Down, Right
The DVD player may show a Region Free message.
Bush 1000
Open the player's tray
Put in a Region 1 disc but do not close tray
Press the 0,1,2 and 3 buttons on the remote control followed by the play button.
Bush 2002
On the player press Open,
On the remote press 7, 7, enter
You are now in the set-up page
Change region to 13 (region free) and while you are there turn Macrovision off.
Bush DVD 2023 & 2024
Press open on the remote
Press 2 then 8 then 1 then 2
Press close.
(TO PLAY VCDS & SVCDS - Insert VCD/SVCD and close tray. Press Goto on remote repeatedly until the menu
says VCD at top of screen.)