Specifications

244
Note: Earlier firmware versions will not play The Matrix or There’s Something About Mary but can be upgraded,
firmware update does not remove setup. This setup also removes Macrovision.
Samsung V7000
If the any of the setups listed below fail to work then you may want to consider using the other codes listed further
down this page. Remember that the steps may need to be entered quickly and from a cold start.
Always perform a Cold Start before applying this setup:
1. Power on your player
2. Press and hold both the Play and Stop buttons on the players front panel
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
If this does not work, try this method for cold boot:
1. Power on your player
2. Press and hold both the FF and Pause buttons on the players front panel (or Stop and Pause, if that does not work).
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
NOTE: for the V7000 model, push play and fast forward for about 10 seconds, then quickly press the Subtitle key as
in step 2.
Converting this player to Multi-Region:
1. The player should be powered on, the tray closed without any disc inside.
2. The logo "DVD Video Samsung" visible on screen and the message No Disc must have already appeared.
2. Press Subtitle on the remote - nothing should appear.
3. Using the remote control, Enter in the code for your original region (see setups above):
Region 1 - 2, 9, 3, 3, 4
Region 2 - 3, 8, 7, 6, 7
Region 3 - 5, 6, 7, 3, 2
Region 4 - 7, 6, 8, 8, 4
Region 5 - 5, 3, 8, 1, 4
Region 6 - 2, 4, 4, 6, 2
4. A number should appear - this is the player's region number that was last programmed.
5. Press the number of the region you require, or 9 for region-free.
6. Open the player's tray using the front panel.
7. Press Standby on the remote control.
Sansui DVX-2100
1. Make sure your player is powered on.
2. Make sure the CD tray is Open.
3. Press 2, 8, 1, 2 on the remote.
4. Press Enter.
5. Use the up and down buttons to select "Region"
6. Change this number to 13 for region free.
7. Select the option below "Region".
8. Change this number to 0 for macrovision free.
9. Press the Eject on the remote control to exit.
Converting this player to Multi-Region if this does not work:
1. Make sure your player is powered on.
2. Make sure the CD tray is Open.
3. Press 2, 9, 1, 8 on the remote.
4. Press Enter.
5. Use the up and down buttons to select "Region"