Specifications

241
2. Press Subtitle on the remote - nothing should appear.
3. Using the remote control, Enter in the code for your original region (see setups above):
Region 1 - 2, 9, 3, 3, 4
Region 2 - 3, 8, 7, 6, 7
Region 3 - 5, 6, 7, 3, 2
Region 4 - 7, 6, 8, 8, 4
Region 5 - 5, 3, 8, 1, 4
Region 6 - 2, 4, 4, 6, 2
4. A number should appear - this is the player's region number that was last programmed.
5. Press the number of the region you require, or 9 for region-free.
6. Open the player's tray using the front panel.
7. Press Standby on the remote control.
Samsung SV-DVD85
If the any of the setups listed below fail to work then you may want to consider using the other codes listed further
down this page. Remember that the steps may need to be entered quickly and from a cold start.
Always perform a Cold Start before applying this setup:
1. Power on your player
2. Press and hold both the Play and Stop buttons on the players front panel
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
If this does not work, try this method for cold boot:
1. Power on your player
2. Press and hold both the FF and Pause buttons on the players front panel (or Stop and Pause, if that does not work).
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
Converting this player to Multi-Region (newer firmware - 5.02E and above):
1. Press Repeat on your Remote Control.
2. Using the Remote enter the code below.
NB1: that you must know what Region your player is currently set to in order to know which code is appropriate:
NB2: for Region 2 use 5, 7, 5, 3, 8 instead of 3, 8, 7, 6, 7. Refer to the table below:
for Region 1 use 2, 9, 3, 3 and 4
for Region 2 use 3, 8, 7, 6 and 7
for Region 3 use 5, 6, 7, 3 and 2
for Region 4 use 7, 6, 8, 8 and 4
for Region 5 use 5, 3, 8, 1 and 4
for Region 6 use 2, 4, 4, 6 and 2
3. A code should be displayed on the screen indicating the current Region setting of your unit
4. Press 9 for Region free, or press 1 for Region 1, 2 for Region 2 and so on
5. Press Open.
6. Press Standby.
Further information has emerged for the very latest players. The only drawback with the below is that it isn't held
when the player is switched off. You also need an Aiwa remote control, our for example the Aiwa RC-7AS08:
1. Turn on the player
2, Open the DVD tray
3. Press Sleep on the Aiwa Remote, and you will see a cold start message on screen
4. Press Clock 3 times very quickly, pressing and pressing, you will see an adjust message on front of DVD player
5. Put any Region of DVD in and it will play