Specifications
239
2, Open the DVD tray
3. Press Sleep on the Aiwa Remote, and you will see a cold start message on screen
4. Press Clock 3 times very quickly, pressing and pressing, you will see an adjust message on front of DVD player
5. Put any Region of DVD in and it will play
NB: It may also work with other Samsung DVD-Mxxx models, but may not work for machines with the 5.02E
firmware loaded. Try the Samsung V-5000 setup, it MAY work.
Converting this player to Multi-Region (older firmware):
If you have:
Firmware version 5.02C (or earlier), or 5.02Ea through 5.02Ed: use REPEAT, 3, 8, 7, 6, 7
Firmware version 5.02Ee (or later): use REPEAT, 5, 7, 5, 3, 8
Firmware version 5.02Da through 5.02E: you can't use this setup until you've upgraded your firmware to version
5.02Ee.
The player may halt on FBI warnings...If the player does freeze at the FBI warnings, Press Forward Search x2 or
faster.
Note: Earlier firmware versions will not play The Matrix or There’s Something About Mary but can be upgraded,
firmware update does not remove setup. This setup also removes Macrovision.
Samsung SV-DVD1EA
If the any of the setups listed below fail to work then you may want to consider using the other codes listed further
down this page. Remember that the steps may need to be entered quickly and from a cold start.
Always perform a Cold Start before applying this setup:
1. Power on your player
2. Press and hold both the Play and Stop buttons on the players front panel
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
If this does not work, try this method for cold boot:
1. Power on your player
2. Press and hold both the FF and Pause buttons on the players front panel (or Stop and Pause, if that does not work).
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
Converting this player to Multi-Region:
1. The player should be powered on, the tray closed without any disc inside.
2. The logo "DVD Video Samsung" visble on screen and the message No Disc must have already appeared.
2. Press Subtitle on the remote - nothing should appear.
3. Using the remote control, Enter in the code for your original region (see setups above):
Region 1 - 2, 9, 3, 3, 4
Region 2 - 3, 8, 7, 6, 7
Region 3 - 5, 6, 7, 3, 2
Region 4 - 7, 6, 8, 8, 4
Region 5 - 5, 3, 8, 1, 4
Region 6 - 2, 4, 4, 6, 2
4. A number should appear - this is the player's region number that was last programmed.
5. Press the number of the region you require, or 9 for region-free.
6. Open the player's tray using the front panel.
7. Press Standby on the remote control.