Specifications

238
The player may halt on FBI warnings...If the player does freeze at the FBI warnings, Press Forward Search x2 or
faster.
Note: Earlier firmware versions will not play The Matrix or There’s Something About Mary but can be upgraded,
firmware update does not remove setup. This setup also removes Macrovision.
Samsung HT-DM150
Converting this player to Multi-Region:
1. Switch Off player and Unplug from mains wait 30 seconds.
2. Reconnect to mains.
3. Turn On player with remote.
4. Press Enter on the remote.
5. Press 8, 4, 2, 6 and 9 on the remote.
6. Press Enter on the remote.
7. The tray will Open and player will power Off and Close tray.
8. Switch On power from remote.
Player is now Region Free.
Samsung SV-DVD1E
If the any of the setups listed below fail to work then you may want to consider using the other codes listed further
down this page. Remember that the steps may need to be entered quickly and from a cold start.
Always perform a Cold Start before applying this setup:
1. Power on your player
2. Press and hold both the Play and Stop buttons on the players front panel
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
If this does not work, try this method for cold boot:
1. Power on your player
2. Press and hold both the FF and Pause buttons on the players front panel (or Stop and Pause, if that does not work).
3. After a short while you should be presented with a set of language options (choose from 1 to 6).
4. Release the Play and Stop buttons on the player.
Converting this player to Multi-Region (newer firmware - 5.02E and above):
1. Press Repeat on your Remote Control.
2. Using the Remote enter the code below.
NB1: that you must know what Region your player is currently set to in order to know which code is appropriate:
NB2: for Region 2 use 5, 7, 5, 3, 8 instead of 3, 8, 7, 6, 7. Refer to the table below:
for Region 1 use 2, 9, 3, 3 and 4
for Region 2 use 3, 8, 7, 6 and 7
for Region 3 use 5, 6, 7, 3 and 2
for Region 4 use 7, 6, 8, 8 and 4
for Region 5 use 5, 3, 8, 1 and 4
for Region 6 use 2, 4, 4, 6 and 2
3. A code should be displayed on the screen indicating the current Region setting of your unit
4. Press 9 for Region free, or press 1 for Region 1, 2 for Region 2 and so on
5. Press Open.
6. Press Standby.
Further information has emerged for the very latest players. The only drawback with the below is that it isn't held
when the player is switched off. You also need an Aiwa remote control, our for example the Aiwa RC-7AS08:
1. Turn on the player