Specifications

200
Disable Macrovision and Enable VCD Playback:
2. Press Down twice:
ver 4001= macrovision enable.
ver 4000= macrovision disable.
NB: press Left and Right arrows to change
3. Press Down three times:
ver 5001= vcd and svcd disable.
ver 5000= vcd and svcd enable.
4. Change to ver 5000 to play vcds or svcds.
Enabling SVCD Playback:
1. Turn on the DVD player.
2. Press Setup.
3. Press 1 1 0.
4. In the lower right of the TV screen you'll see the message ON
when you repeat these 3 steps it will display OFF.
5. After entering the code - exit the SETUP menu and power off the player.
6. When powering on the DVD player the setup works!
Enabling SVCD Playback:
1. Press Setup.
2. Press 1 1 9.
3. After pressing each number wait till the hand disappears.
4. If you do it correctly a message HAVE VCD will appear.
Q
Quadro 700
Same as the Skyworth DVD-650S - Open cd drawer, Key in (using remote) 8926# (# = region code number i.e. 1,4
etc. 0 = multi region and no macrovision)
R
Radionette RN3100
1. Power on the player with no disc in the drive.
2. Press Pause, 3, 1, 4, 1, 5 and 9 on the remote
3. The word COde appears on the DVD display for a few seconds.
4. Enter region code required on remote (before COde disappears), using 0 for region free if needed.
5. Press Pause on the remote control.
6. Power the player off and then back on.
7. Keep trying with the setup as this may take a few attempts to work.
Firmware Version Display:
1. Press Setup on the remote.
2. Select 'TV Aspect'.
3. Place cursor on '16:9 wide'.
4. Using the remote control, key in the following: 1, 3, 9, 7, 1, 3, 9.