Specifications
184
5. Press the Play button on the DVD player's Remote
6. The onscreen display should now show the words No Disc
7. Power off your DVD player, wait 10 seconds and then power back on
You may also use the following methods for players with firmware 6.2:
1. Turn your DVD player on
2. The display will show you no disc
3. Press Play and then press 1, 5, 9 on the DVD Remote
4. On DVD display will appear ------ -----
5. Key in 101 040 000 140 on the Remote when you press the last digit you will see a little point
6. Press Play
7. The player will be turned off
Your DVD is ready
Converting the player to Multi-Region if the above does not work:
Region 1:
1. Press PLAY, 2, 7, 4 on the remote control.
2. When the display reads '--', press 005 000 128 156 on the remote control. The player is in region 1 mode.
3. Press PLAY on the remote.
Region 2:
1. Press PLAY, 2, 7, 4 on the remote control.
2. When the display reads '--', press 002 000 128 156 on the remote control. The player is in region 2 mode.
3. Press PLAY on the remote.
Reset to factory defaults:
1. Press PLAY, 1, 5, 9 on the remote control.
2. When the display reads '--', press 004 010 000 140 on the remote control. The player is in region 1 mode.
3. Press PLAY on the remote.
Philips DVDR 70
Via the "System" button on your Philips remote, on your recorder (no disk in recorder), change the "Remote control
used" from "DVD Recorder" to "DVD Player". Store it. (This is IMPORTANT!)
Using the Philips remote press Play 159 (The display on the recorder should now change to eleven dashes).
Press 121 212 005 255 (the last few digits will NOT be visible on screen but they WILL be there).
Press "Play"
Power down your recorder, wait a few seconds.
This is now region free.
Using "System" button on your Philips remote, on your recorder (no disk in recorder), change the "Remote control
used" from "DVD Player" to "DVD Recorder". Store it.
Philips DVDR-880
You will need a One-4-All universal remote for this (Send the infra-red code RC6 (aka Codeset 4, Key 235)):
1. Set up the remote with the code 0, 5, 3, 9.
2. Press the MAGIC button.
3. Press 085. The display should read '----'
4. Enter the following with the normal Marantz remote: 222 222 005 255.
5. Press Enter.
6. The player should now be region-free.
To change to a specific region: