Title_.fm Page 1 Jeudi, 4. février 2010 1:15 13 DTR 230 DTR 232 www.philips.
DSR220co.book Page 2 Lundi, 18. janvier 2010 6:23 18 Contents 1 1.1 1.2 Quick Start Guide Connecting to a television Connecting to a television and recorder 3 3 2 2.1 2.2 2.3 Introduction About this user manual Safety and precautions Environmental Markings 4 4 4 7 3 3.1 3.2 3.3 3.4 3.
DSR220co.book Page 3 Lundi, 18. janvier 2010 6:23 18 1.1 Quick Start Guide ENGLISH 1 Connecting to a television TV set - rear UHF aerial SCART input on TV RF cable (not supplied) RF Out connector Receiver rear panel 1.
DSR220co.book Page 4 Lundi, 18. janvier 2010 6:23 18 2 Introduction Thank you for purchasing this product which has been designed and manufactured to give you many years of trouble-free service. 2.1 About this user manual This user guide contains all the information you need to know about how to setup and watch available 'Freeview' channels using your digital terrestrial receiver. 2.
• In order to completely disconnect the device from the power supply, the pluggable power supply has to be disconnected from the power outlet. • Have repairs or settings on your receiver carried out by qualified skilled personnel only. Unauthorised opening and repair attempts will result in loss of warranty. The manufacturer accepts no liability for accidents of the user if the device is opened. Incorrect wiring of the connections can result in failures or malfunctions on the device.
DSR220co.book Page 6 Lundi, 18. janvier 2010 6:23 18 Batteries • Batteries are to be kept away from children. • After swallowing a button cell or battery, the person concerned has to consult a doctor immediately. • Do not try to reactivate used batteries by heat, charging, or by other means. • Batteries may not be thrown into the fire, disassembled, or short-circuited. • Replace the batteries at least one a year to prevent them from leaking.
DSR220co.book Page 7 Lundi, 18. janvier 2010 6:23 18 • "By using the standby mode you will save energy (and therefore money) and reduce carbon dioxide emissions that damage the environment. • "You use the standby button on your remote control to switch between On and Standby modes. • "There will be an additional delay (few seconds) when you switch on your set-top box from the standby mode.
DSR220co.book Page 8 Lundi, 18. janvier 2010 6:23 18 3 Getting Started Remove your Digital Terrestrial Receiver carefully from the box, and remove the packaging from each part. In the box You will find the following items: • Digital Terrestrial Receiver • Remote control (AAA batteries) • Power supply 230 V AC/50 Hz to 12 V DC • User Manual (this publication) If any of these items are damaged or missing, please contact us at 0800 331 60 15.
DSR220co.book Page 9 Lundi, 18. janvier 2010 6:23 18 3.1 Identification of parts ENGLISH Remote Control Power On/Off (Stand-By) I-II key (Audio selection) TIMER key Colour keys Teletext TEXT / Pg UP key Pg DOWN key INFO key OK key EXIT key Volume up/down EPG key Cursor keys BACK / P
DSR220co.book Page 10 Lundi, 18. janvier 2010 6:23 18 3.3 Digital Terrestrial Receiver Front view IR receiver / Green LED, Normal operation - off, Standby - on Rear view RF In from antenna RF Out Scart output/input connector for VCR and DVD units 3.4 Scart output connector for TV Power supply, 12 V DC SPDIF (digital audio out) Power supply Power cable (1.
Note that the only recommended way to disconnect the Digital Terrestrial Receiver from the mains supply is to remove the adaptor from the mains socket. If the mains socket is fitted with a switch, this could be used instead. Receiver Power supply adaptor +12V DC To 230V AC mains supply Receiver rear panel 3.5 Connecting your Digital Terrestrial Receiver to other equipment The following diagrams are of typical configurations only, and may differ slightly to your existing external equipment.
DSR220co.book Page 12 Lundi, 18.
DSR220co.book Page 13 Lundi, 18. janvier 2010 6:23 18 4.1 Operation Switch-on/switch-off Switch the receiver on by pressing the ON/OFF 1 key (standby key) on the remote control and wait until you see the welcome image on your screen. • The LED is off if the receiver is switched on. • When you switch on your receiver for the first time, the LED is blinking while the software is loading. Follow the steps explained in the section 2 Initial installation on this page.
DSR220co.book Page 14 Lundi, 18. janvier 2010 6:23 18 Automatic search The next window is displayed: Note The displayed values for the start and stop frequency can normally be maintained. 7 Make use of the arrow keys or to modify the start and end frequency values, if desired. 8 By means of the arrow keys or you determine the channels to be searched for: All channels, or channels that are Free-toair only.
DSR220co.book Page 15 Lundi, 18. janvier 2010 6:23 18 4.3 Ready for watching TV 4.5 Volume control • Use the volume keys + and - for increasing or decreasing the volume, or • use the arrow keys or for this purpose. Mute function By pressing the MUTE key, the sound reproduction is stopped. The sound is audible again if you ... • ... press the MUTE key again, or ... press one of the volume control keys. As soon as the search is completed, an according • message is displayed.
DSR220co.book Page 16 Lundi, 18. janvier 2010 6:23 18 information banner by pressing the INFO key again. The extended information banner supplies further details with regard to the current program. This means that, for instance, a sound, subtitles, or text selection is provided. How to use the options: 1 Call up the desired channel. If the text is more extensive, it is distributed 2 Press the I-II key for sound selection. to several pages.
DSR220co.book Page 17 Lundi, 18. janvier 2010 6:23 18 Press the I-II key for quick access to language selection. TIMER Press the TIMER key for quick access to the Timers menu. LIST/FAV Press the LIST key for quick access to Favourite Lists menu. 4.9 Using channel list 1 By using the arrow keys or , you skip eight positions in the channel list forwards or backwards. 3 Use the TEXT /Page up and the Page down keys to display the proceeding or the next page.
DSR220co.book Page 18 Lundi, 18. janvier 2010 6:23 18 3 After you have carried out the desired settings, press the EXIT key in order to close the window. Defining channels as your favourites The favourites list contains all channels you have defined as favourites. By means of this list, you can create a personalised channel list. 1 Select the channel you want to indicate as a favourite by using the arrow keys or . 2 Press the OK key to add the channel to the favourite list.
DSR220co.book Page 19 Lundi, 18. janvier 2010 6:23 18 Following, the scan mode is started. • If some channels were found, you receive the same request as with regard to the automatic scan mode, see previous paragraph. • If no channels were found, a message is displayed. Press the OK key. 4.
DSR220co.book Page 20 Lundi, 18. janvier 2010 6:23 18 • • • Via the arrow key and , you can select 4.13 Timer programs earlier or later in the day. By pressing the channel + or - key, you can The Timer settings allows you: view the EPG for another channel. If you want to adopt a program into the timer list, highlight it and press the TIMER key. Acknowledge the following request by pressing the OK key. Note Detailed information on the subject "timer" can be found in the next paragraph.
DSR220co.book Page 21 Lundi, 18. janvier 2010 6:23 18 Switching off current timer functions To modify an existing Timer, highlight the relevant Timer in the list and press the OK Note key. During a timer program, only few keys can be activated: I-II, the volume keys + and -, as well as the MUTE key. To switch off the timer function: 1 Press On / Off. A program message is displayed. The Station field displays the channel name 2 Press the OK key. and is highlighted. To change the channel press OK.
DSR220co.book Page 22 Lundi, 18. janvier 2010 6:23 18 Displaying channel and system information / adjusting the antenna This function solely serves to supply information on one channel. However, you can use it for adjusting your antenna and for improving the television reception. 1 Press the MENU key to open the main menu. 2 Highlight the item Technical information by using the arrow keys or , and press the OK key. 3 Select the item Channel information and press the OK key.
DSR220co.book Page 23 Lundi, 18. janvier 2010 6:23 18 Automatic Presents the images in the 4:3 format in a screen-filling manner. However, the image is vertically compressed to avoid cutting of the top and bottom picture border. Pillar box Reduces a 4:3 mode picture for 16:9 format TVs to scale, and for this purpose inserts a black bar left and right 3 By using the arrow key or , highlight the desired option and press the OK key in on the screen. order to call it up.
DSR220co.book Page 24 Lundi, 18. janvier 2010 6:23 18 Letter box 14:9 This setting represents a compromise between the other two settings. Small black bars are inserted and only a bit of the left and right picture border is cut off. TV Output Format For the "TV Output Format", the formats RGB, video (CVBS) and S-Video (Y/C) are provided. Here RGB presents the correct selection in most cases.
DSR220co.book Page 25 Lundi, 18. janvier 2010 6:23 18 4.21 Miscellaneous Settings This option is only available if the value set under "display duration information banner" is at least Setting a time zone Select whether the local time offset with regard 4 seconds. to Greenwich mean time is to be set Menu Transparency automatically, or if you want to specify it yourself. Here you set the transparency of the OSD.
DSR220co.book Page 26 Lundi, 18. janvier 2010 6:23 18 4.22 Calling up default settings This function has already been described elsewhere, see page 21. 4.23 Security 1 2 3 Press the MENU key. Highlight the item Security by using the arrow keys and press the OK key. Enter the PIN code and acknowledge by OK. When the menu is called up the next time, the PIN request is effected (the PIN code is set to 0000 by the factory). Channel lock Here you can protect specific channels from unauthorized access (e. g.
DSR220co.book Page 27 Lundi, 18. janvier 2010 6:23 18 Upkeeping Trademarks and partner logos PHILIPS and, the PHILIPS Shield Emblem are registered trademarks of Koninklijke Philips Use a soft, moist (but not wet) cloth for cleaning. Electronics N.V. and are used by Pace PLC under You must not use scouring cloths or sponges or license from Koninklijke Philips Electronics N.V. spraying bottles. Pace and are trademarks and/or 5.2 Maintenance registered trademarks of Pace plc.
DSR220co.book Page 28 Lundi, 18. janvier 2010 6:23 18 6 Troubleshooting If you experience an operating problem with your Digital Terrestrial Receiver, please refer to the trouble-shooting table below and then the notes that follow.
DSR220co.book Page 29 Lundi, 18. janvier 2010 6:23 18 Possible cause Certain stations cannot be received from time to time These services are not transmitted 24 hours a day and can sometimes be unavailable. This is not a fault.
DSR220co.book Page 30 Lundi, 18.
DSR220co.book Page 31 Lundi, 18. janvier 2010 6:23 18 EXT 2 SCART • Outputs: ENGLISH • CVBS* , L/R audio Inputs: • CVBS* or RGB/FB, L/R audio, Slow blanking Digital audio output: Cinch * Video standard: PAL Front panel: Display / Buttons • 1x LED Accessories • Remote control • Batteries: 2 x 1.5V type AAA/R03 • User manual • AC /DC Power adaptor incl.
DSR220co.book Page 33 Lundi, 18. janvier 2010 6:23 18 © 2009 Koninklijke Philips Electronics N.V. All rights reserved.
