Datasheet

Problem Possible cause / Solution
Camera • Check if the camera power is turned on. If not, turn it on and then
connected to PC connect the camera to the PC again by placing it on the docking base.
but the Philips Pocket
Cam driver says:
‘Device not ready’.
Photo is blurred Camera or object was moving when photo was taken
or dark • Hold the camera firmly.
Subject is too close
•Move away from the subject.
Lens is dirty
• Clean the lens with a soft cloth.
Flash does not work Flash not finished charging
•Wait until the green Charge LED remains lit.
Flash not turned on
• Set Flash to ‘Auto’ or ‘On’. See ‘Menu operation’ - ‘Photo taking mode
menu’.
Camera will not Subject is not in centre of viewfinder or display
focus •Move subject to centre.
PC does not USB connection not properly made
recognize camera • Properly connect USB cable to both docking base and PC and be
sure the camera is placed on the docking base.
Interference from other USB devices
• Disconnect other devices.
Camera software and drivers not installed
• Install camera software and drivers (see ‘Installing the camera software
and drivers’).
Camera malfunctions Electrostatic discharge interfered with the camera
during use •Turn the camera off and then then back on again.
• If connected to PC:Take the camera off the docking base and then turn
it off and back on again.
Display does not LCD was turned off before the camera was last turned off
light up • Press the LCD button to turn on the display.
Display shows ‘E2’ Incompatible file system on SD memory card
when SD memory • Format SD memory card (see ‘Menu operation’ - ‘Playback mode menu’.
card is inserted
ENGLISH 31